Samsung eco bubble Washing machine UE error code
hi I have a samsung eco bubble 7.0kg and it is reading UE on the display any ideas?
Mel
Hi Mel
Washing machine has detected an imbalanced load
This error code is more for information purposes than actually a fault as such. What the washing machine is telling you is that it has been unable to sort the laundry load and correctly spin without a risk of damage due to an unbalanced load. This error will clear when you restart the machine but do sort the laundry reduce or increase the load as required and for more information on load imbalances please see this article.
- Reload the washing machine and attempt to spin again
- Check the installation of the washing machine for level and balance
- Check for small loads as small loads will cause an imbalance error
My Samsung washing machine not draining pump is getting on but water isn’t goin out, any ideas?
My Samsung eco bubble just stopped spinning. I’ve cleaned the pump thing. And I’ve opened the back and the belt is still on and is turning manually. It fills up then just stops. All lights still working ok .
My washing machine has intensive simple showing above delay end and also door lock symbol showing. It will not start doing any wash and I have switched it on and off. Door is locked.
My Samsung bubble wash 7.5kg just stopped spinning. I’ve cleaned the pump thing. And I’ve opened the back and the belt is still on and is turning manually. It fills up then just stops. All lights still working ok . The motor is DC9300316A and shows the code 3E
my machine is displaying 5C, any help appreciated,thanks
My samsung ecobubble 8kg I’d displaying the UE code have tried the tips above and tried with no washing in at all and is still showing this UE code. It works till it has 7 mins left then goes to UE. Any advice please
I have samsung eco bubble with a problem. When I load the machine and select any program, then press start, the machine starts the pump for nearly 3 to 4 minutes without taking in any water. Also, the drum does not move and all electronic controls are inoperable. No error message on the display, but after about 15 seconds from pressing the start button, the machine makes a beeping sound (which only appeared since the fault).
The water inlet tap, pipe and filters are all ok. The water inlet valve is reading ok on a multimeter. Any help is appreciated