Bosch WAE24368GB Washing Machine goes through full cycle to finish, but it is spinning very slow and washing still very wet.I have remove the drain which is clear. Could it be the control panel and have you got one. Thank you for your assistance in this matter.John

Hi there, thanks for your video on YouTube regarding a teardown of a Bosch WAE24368GB washing machine. Having followed the process I have been able to confirm a broken spider on my 12+ year old machine. Given the cost to repair I have decided to buy a new machine. Do you have any recommendations on which machine to buy in terms of reliability/quality, etc. I have a budget of around £500, and would like 7-8kg capacity.
Also would you like any of the parts from the old machine (for free)? Am based near Milton Keynes if you are ever over this way.
Many thanks
Adam

We have a single parent mother and are trying to assist. She has the Siemens WM14P360GB washing machine that stopped functioning with an E43 fault which is listed as brushes.
I have replace the brushes though there was still some wear left on the old ones.
The motor will still not run in any wash selection.
It drains, fills, door opens and the timer at the end of a program still shows 1 min without a door opening and does not clear.
I do not have a test rig for the motor and have not been able to configure the wiring as yet and have found connection 3 to be for both brushes not individual brushes l and right,.
Can you advise
Thanks,
Robin

I have Bosch WFVC8440UC/19 washing machine. There seems to be a leak in the tub above the drive motor where the company filled a seam/gap with some sort of black glue. Is this seam standard on tubes?

Greetings Paul
Very helpful videos on your YouTube channel !
Could you tell me where i can find the codes for :
Bosch 500 series WAT28401UC/12 washing machine
The only code I know is the child lock.
I am looking for the codes to reset the electronics / sensors. ( aside from turning off the breaker which doesn’t do anything really )
I’ve seen you doing a reset technique with another model …. but it doesn’t seem to work on my machine.
I have no error messages. But the machine keeps telling me the door isn’t closed (even if it is.)
Thank you so much for your time. Any information would be greatly appreciated