We have a single parent mother and are trying to assist. She has the Siemens WM14P360GB washing machine that stopped functioning with an E43 fault which is listed as brushes.
I have replace the brushes though there was still some wear left on the old ones.
The motor will still not run in any wash selection.
It drains, fills, door opens and the timer at the end of a program still shows 1 min without a door opening and does not clear.
I do not have a test rig for the motor and have not been able to configure the wiring as yet and have found connection 3 to be for both brushes not individual brushes l and right,.
Can you advise
Thanks,
Robin

Bosch WAS28461GB/07 washing machine gave error during wash cycle, door locked, switching off then selecting any option, drain, spin, etc, immediately gives E:57 error again. Tried resetting to no avail. Google searching suggests possible PCB Inverter circuit fault. Is it worth trying to repair? I recently fitted a new drum/door seal which will be wasted if machine written off.
Thanks for any help offered.

Hi Paul – love your u-tube videos, but struggling to access your on-line shop – contacting you here in the off-chance that you are able to supply a replacement door lock for my Seimens WM14S392GB/08 washing machine – either that or please point me in the right direction to source one. Many thanks and kind regards, Phil

HI PAUL THANKS FOR YOUR PROMPT REPLY TODAY SPENT SOME HRS TODAY TRYING TO FIND FAULT
1 CHANGED FILTER WITH SPARE I HAD FAULT STILL THE SAME, REFITTED OLD
2 REMOVED DOOR SWITCH
CHECKED OK, REFITTED
3 RECHECKED ALL WIRING AND PLUGS ALL SEEM OK
THIS IS WHAT I THINK
I SET MACHINE TO DRAIN
PUMP ON OK, PANEL SHOWING SPIN LIGHT ON
BUT NO MOVEMENT OF DRUM, EVEN WHEN I HAD PROGRAM SET TO 15 MIN WASH IT FILLED STARTED
AGITATING OK HEATER HAD 240V THEN WHEN I THINK IS WAS SUPERPOSED TO SPIN the WHOLE MACHINE SHUT DOWN, THE ECO SILENT DRIVE HAS An INVERTER
IN A BOX AT BOTTOM
I HAVE NOT HAD IT OUT YET BUT WHAT DO YOU THINK IF THE MACHINE CAN’T SPIN WOULD IT SHUT DOWN OR JUST SETTING PROGRAMMER TO A SETTING THEN AFTER 30 ODD SECONDS MACHINE SHUTS DOWN IS IT CHECKING THEN FINDS A PROBLEM WITH INVERTER OR MOTOR AND SHUTS DOWN? BUT NO-FAULT CODE OR PERHAPS THIS MODEL DOES NOT HAVE A FAULT CODE FOR INVERTER? IT IS NICE TO HAVE SOMEBODY TO ASK ABOUT THE PROBLEM
I RETIRED BUT BEN A MAINTENANCE ENG ALL MY WORKING LIFE
MANY THANKS BOB FRI 21.50

SWITCH ON MACHINE AND SET PROGRAM AFTER ABOUT 30 SECONDS THE CONTROL PANEL SWITCHES OFF/BLANK , TRIED 15 MINUTE WASH
FILLED STARTED TO HEAT AND WASH THEN AS ABOVE PANEL SWITCHES IT SELF OFF ,EVERY TIME I SWITCHED OFF SUPPLY
TO RESET BEFORE TRYING AGAIN, CHECKED CONTROL BOARD /PLUGS/WIRING LOOKS OK ?? SEEMS TO ME A FAULTY COMPONENT SOME WERE SHUTTING MACHINE DOWN BUT WITHOUT A ERROR CODE
I AM PUZZLED BE MOST GREAT FULL IF YOU HAVE ANY IDEAS THANKS BOB