I have Candy GCC 590NB-80 Tumble Dryer. Fairly sure that the Capacitor requires replacing but can’t find anywhere on this page to search for a replacement. Link on front page doesn’t show any capacitors.

Hi paul and the team. I have Candy GVC D91CB-80 tumble dryer displays the above code and also an intermittent bleep and not drying. Please help.

Hi paul hope you are ok. I have Hoover VTV581NC-80 vented tumble dryer and I need new replacement please advise, kind regards

My Hoover VHC 691B tumble dryer stopped working, it was totally dead, with no functionality or lights working. Checking the circuit board I could see the chip had broken apart (I’m guessing it overheated and exploded because the water tray and fluff tray were both full), so I replaced the circuit board. However when I then tested it the tumble dryer stopped and beeped when I put it on a sensor programme and if I tried it on a timed programme it went straight to the spin cycle bypassing the heat part of the programme (the heat light didn’t light up and the spin one did). I ended up buying a new heater complete with new thermostats however the tumble dryer is still showing the same symptoms. What else could the fault be? I was thinking maybe the NTC sensor is broken however I’ve tested it with a multimeter and it’s showing an Ohms reading on the 200k and 2M setting but nothing on the lower Ohms settings. I can’t seem to locate any other thermostats in the tumble dryer apart from the two on the heater that were replaced with the heater. I also can’t locate a thermal cut out switch, to see if this needs resetting.
Many thanks.
Chris

I recently replaced both motor capacitors on my Hoover DXH9A2TCE80/ condenser tumble dryer but I now have the E13 fault showing after about 5 minutes of operation.