My Beko WTK92151W Washing Machine does the cycle, fills, washes, drains and then spins, like normal. After the final spin the screen just goes through it’s time adjustment. Normally it reaches 0 on the clock. The drain pump does a short final drain, the display then says end and the door lock clicks.
The screen just cycles round and the drum rotates slowly back and forth. I have to manually press the stop/start button to get it to end. It appears to be filling OK. The heater is working and I have checked the pump & drain pipe.

Beko WM5101W washing machine will fill, turn drum in both directions, heat water then continue to turn one way for 10 seconds (approx), pause for ten seconds, then turn the other way for ten seconds for as long as I care to let it. Up to 20 minutes before I give up waiting for a drain and refill, and press and hold ‘Cancel’. The machine immediately stops, runs the pump to empty the suds and lights ‘Spin/End’. Can you advise, please, why the machine will not follow through any wash program, and what a solution may be?
With thanks.
( I found you on YouTube and am a subscriber)
(

The machine is less than 2 years old and out of guarantee and very noisy when spinning and grease deposits on door and seal

Hi Paul firstly how do I buy u a pint? Second I cleaned filter (was clogged I’m with face mask!) then changed bushes it now spins but is noisy any ideas? I didn’t sandpaper the com part. Do u think I could have fitted the carbon brushes wrong? Or could it be the belt I didn’t but a new belt.

For a few weeks the spin cycle was incredibly noisy and now the drum doesn’t turn at all – the motor is working, it’s draining but the drum doesn’t move – there’s resistance if you try turning by hand. Could this be a drive belt or something else?
Thanks