Hi I have a Beko WM5100W Washing Machine. It has power and lights but won’t start washing. The wash light did light, but the cycle didn’t start. And then when I didn’t the cancellation process (hold start for 3 seconds), the End light lit, but the cycle hasn’t ended. Can you please give me any ideas for how to diagnose what the fault is, so I can replace the relevant components?

Beko WM5101W washing machine will fill, turn drum in both directions, heat water then continue to turn one way for 10 seconds (approx), pause for ten seconds, then turn the other way for ten seconds for as long as I care to let it. Up to 20 minutes before I give up waiting for a drain and refill, and press and hold ‘Cancel’. The machine immediately stops, runs the pump to empty the suds and lights ‘Spin/End’. Can you advise, please, why the machine will not follow through any wash program, and what a solution may be?
With thanks.
( I found you on YouTube and am a subscriber)
(

I have a Beko WM5100 Washing Machine. Spin/drain missed off the program. Goes straight to the end of the program and can be opened. Separate spin/drain will do the job after a couple of tries. All items working in test mode.

I have beko wm5100w washing machine and it stopped working after overfilling with a light load that has a large volume (a pillow).
Here is a link to the video showing that the drum doesn’t rotate/spin during the test sequence.
https://youtube.com/shorts/EGWFkQ-aDdY?si=gZKx51DPOZ48Aagr

Having stripped the Beko WMB61431B washing machine and removed pump I found the impeller has come on. I bench tested the motor was working lumpy sounding at start and impeller flew off. I was unable to carry out a Ohms test I don’t know how to do this and read the results. In some previous questions with the impeller at fault off (It should be fixed) are you saying I need a new pump motor. please let me know and your you tube is very very helpful thanks Howard.