Beko WM5101W washing machine will fill, turn drum in both directions, heat water then continue to turn one way for 10 seconds (approx), pause for ten seconds, then turn the other way for ten seconds for as long as I care to let it. Up to 20 minutes before I give up waiting for a drain and refill, and press and hold ‘Cancel’. The machine immediately stops, runs the pump to empty the suds and lights ‘Spin/End’. Can you advise, please, why the machine will not follow through any wash program, and what a solution may be?
With thanks.
( I found you on YouTube and am a subscriber)
(

I have Beko WTG620M1W washing machine. I put it on daily quick 30° all work fine till the rinse bit where you here it working and water going in and the couple off mins later it flashes and I have to press start again is this right just need some advice thank you Mark

Hi Paul I have a fault with my Beko WTG620M2W washing machine i have drained the drum of all the water. And when I turn it on you can hear and see the drum try to turn with no joy. When I have removed the bet to test the motor it works fine, I have also looked at the brushes they are worn but not to low, do you have any ideas what It could be cheers
Curtis

Hi paul, I saw your youtube channel great videos thank you. I have a Beko wm62125w washing machine slimline 6kg model. It fills with water and then stops. What could be the problem? Do I need the reset the machine or something else?

I have Beko WMB61432S washing machine. After selecting the program to wash or spin, the machine only starts after slamming the door several times. The last error code is E17 (over foaming), so could this be that the switch just inside the door is faulty?
Many thanks for any help.