Watched your video online. Took the cover off the back of the Candy GVS C9DCGB-80 tumble dryer, disconnected the cables from the 2 thermostats and the one on the left hasn’t got continuity. I’m guessing that’s the issue?

Hi, pump runs when 230v placed across the terminals, float level switch opens/closes, continuity of cabling from pump and switch to PCB connecter confirmed OK
I suspect main board but cant remove knob to examine board, thoughts?
Chris

Cleaned filter, condenser, compartment etc allowed to dry out. Still happens. Runs for a few minutes and then when it changes a cycle briefly stops to start again it stops and e21 code comes up. Can you help please? Only had it for about 2 months. Many thanks. Neil

Hi there,
My condenser dryer runs for a few minutes then stops with all all LEDs flashing with a beeping sound. Ive watched your video on how to fault find and it appears that I have no continuity over one of the thermostats at the rear. Please can you advise on this so I can be sure I purchase the right replacement part from you.
Many thanks
Tim
PS free beer for a speedy reply.

Keeps flashing up err15 code. tried unplugging for 10 mins but doesn’t clear error so think I need to do a reset but dont know where the reset switch is located. I think it has tripped due to me not emptying/cleaning the condensor unit recently because when I checked the unit it was pretty full of fluff and also feathers/down that had come off a duvet cover being used on a new feather duvet so I assume it has caused it to overheat and trip the sensor??? Can you jut tell me how to do the reset so I can eliminate that as the reason?? many thanks.