You can refine your search further by entering make and model number if you are looking for parts.
If you are looking for tutorials please use appliance type only.
If you need help please use
FAQs or ask a question in contact us page.
Having trouble with layered Navigation?
Watch Video
My Hoover VHC 691B tumble dryer stopped working, it was totally dead, with no functionality or lights working. Checking the circuit board I could see the chip had broken apart (I’m guessing it overheated and exploded because the water tray and fluff tray were both full), so I replaced the circuit board. However when I then tested it the tumble dryer stopped and beeped when I put it on a sensor programme and if I tried it on a timed programme it went straight to the spin cycle bypassing the heat part of the programme (the heat light didn’t light up and the spin one did). I ended up buying a new heater complete with new thermostats however the tumble dryer is still showing the same symptoms. What else could the fault be? I was thinking maybe the NTC sensor is broken however I’ve tested it with a multimeter and it’s showing an Ohms reading on the 200k and 2M setting but nothing on the lower Ohms settings. I can’t seem to locate any other thermostats in the tumble dryer apart from the two on the heater that were replaced with the heater. I also can’t locate a thermal cut out switch, to see if this needs resetting.
Many thanks.
Chris
After watching your great videos. I have replaced all thermostat and the heater element but still stops after a few seconds with the lights flashing. a couple of times the heater did start but the stopped and beeped again. I think the only thing it could be is the PCB board part number 40005134. Would i be able to buy one or send it of to you for repair.
Thank you.
Hi there,
My condenser dryer runs for a few minutes then stops with all all LEDs flashing with a beeping sound. Ive watched your video on how to fault find and it appears that I have no continuity over one of the thermostats at the rear. Please can you advise on this so I can be sure I purchase the right replacement part from you.
Many thanks
Tim
PS free beer for a speedy reply.
September 23, 2024 
