You can refine your search further by entering make and model number if you are looking for parts. If you are looking for tutorials please use appliance type only. If you need help please use FAQs or ask a question in contact us page.
Having trouble with layered Navigation? Watch Video
January 17, 2018 
Hello
I need some advise with respect to what I should change on my dryer. It initially came up with an error code of F04. I reset the error message and now it comes up with error F06. When I switch it on the drum turns and then after 20sec the dryer stops and the error message flashes. Please help!
Warm regards
Aftab
June 11, 2024
Hi Paul, we have a Hotpoint TDWSF83BEPUK condenser tumble dryer, I’m wondering if F19 Error is a heating element on this tumble dryer and if replacing it would resolve the issue.
One was wondering if you could advise us on it. It’s probably not rocket science to replace a heating element at the rear. I’m pretty confident I can fix it myself. Just needed to know if you think the error code F19 is an heating element issue. Or know the part number I need to replace it.
Thanks James
January 20, 2021
TDWSF83BEP on 15min timed programme runs til 5 mins remaining, both high & low heater sides run at approx 10amps for 5 mins then drops to approx 5amps just low side(heats, spins both ways, pumps etc.up til this point) carries on for several more minutes then F19 error. Heat element 2 x 1200w, 42.5ohm each total=85ohm. Heat stat (type261/bp 180deg 20-16)180deg cut out reads short cct, heater ntc (type 279 23-16 3111 T200)approx 12kohm @ 20deg, decreases with heat. Fan ntc(2790046 48-16)12kohm @ 20deg approx decreases with heat. Fan, ducts, filters, condenser, water reservoir all cleaned and clear. Flood float reed switch normally short cct (empty reservoir), open cct when lifted. Condenser reed switch normally open cct, short cct when condenser unit in situ. Control bd diodes, resistors, caps all within reasonable tolerance, relays operate in-cct with 9v applied, short or open cct.
Display bd checks ok, mom switches, diodes. leds, resistors ok. Max6959 (display interface) not tested but appears to function ok, 7 segment display working ok.
Wiring checked for continuity, shorts, leaks etc all ok.
Direct drive motor not yet checked, cct bd on motor, Askoll type TA0200, would need to remove bearings to gain access to cct bd.
Is the motor/cct bd the likely culprit here?
Apologise for lengthy detail but driving me nuts, thanks.
January 19, 2021
COULD IT BE THE RELAY ON PCB BOARD
January 15, 2021
Metal sensor strip caught up in clothes & snapped off.
How can I gain access to attach a new one. Do you sell the part I need? Does one end attach to a spade connector?
No Posts found.
