I have just watched your review video on the Asko washing machine. I have an Asko W2084C washing machine which is a cheaper machine in the same series. I have a couple of comments on the video and then I have a question.
The first comment is in response to your observation about the difficulty in opening the filter door, The washer has a tool for opening the filter door which is held in the back of the detergent door. You need pull the detergent drawer right out to get to the tool. It slides into a couple of grooves on the underside of the drawer.,
The second comment concerns your observation about the water hose. The hose on Asko machines is made of PEX and will never burst. I have had a hose on a washer of another brand burst and created an absolute mess in the laundry.
Now to my question: I have found that the door seal on my machine is leaking, particularly during the drum wash cycle. I have inspected the seal and the ring against which the seal sits. They both look fine. I then spoke to an independent appliance repairer who told me that Asko found a deficiency with the double-articulated hinge design that was the cause of the seal leaking. He claimed that Asko has produced a modified hinge which is now being fitted to the latest machines. There are many reports of current generation Asko washers leaking, but I have not heard about the hinge having been redesigned from any other source. I would like to confirm that this is the case, before I spend significant money on having the hinge of my machine replaced. Are you able to confirm whether Asko has redesigned the hinge? If so, do you know from when the redesigned hinge was being fitted to new machines?

Good Afternoon, I’ve been watching your videos with keen interest. I have the Beko WMB71642W washing machine which isn’t always draining fully on first attempt. The drain pump had become noisy so have changed it for the second time now and am just wondering whether you have any advice, before my wife gets her way with buying a new machine? I was wondering whether it is the pressure switch or hose and just saw your disassembly video, so was just wondering whether a clog in the the drum where the pressure hose connects can be checked before replacing any more parts?
Thanks in advance,
Mark.

Hi I have a Beko WM5100W Washing Machine. It has power and lights but won’t start washing. The wash light did light, but the cycle didn’t start. And then when I didn’t the cancellation process (hold start for 3 seconds), the End light lit, but the cycle hasn’t ended. Can you please give me any ideas for how to diagnose what the fault is, so I can replace the relevant components?

Hi, I have a Beko WMP601W washing machine. After a regular wash cycle my machine seems to be leaving water in the drum so the clothes remain soaked. However, when I then set the machine to a spin+drain cycle, the water is clearing fully. This doesn’t make sense to me. Can anyone explain why this could be? I’ve already checked the filter, waste hose, sink trap and the impeller appears to be spinning correctly with that little elastic resistance when I turn it with my finger.
Thanks in advance

Bosch WAE24368GB Washing Machine goes through full cycle to finish, but it is spinning very slow and washing still very wet.I have remove the drain which is clear. Could it be the control panel and have you got one. Thank you for your assistance in this matter.John