Dear Paul, I am from Germany and faced the problem with my 4 year old AEG L6FBA48 washing machine 6000 ProSense and maybe you can give me some advice here. Washing machine display and one program diode are blinking in standby mode (i.e. machine is off and connected to wall socket), when I turn it on – blinking elements are slightly visible and remaining elements of display are show without problems. The machine works without problems whatsoever (no error codes, nothing), except this blinking during standby. My machine is standing in the stack (aeg dryer is on top) and connected in neighboring socket, but the dryer has no issues whatsoever. Both machines were never moved around or transported and always stay in same place. To visualise the problem there is a reddit post about it. https://www.reddit.com/r/Appliances/comments/1f3l6pa/aeg_washing_machine_blinking_red_lights/ I’ve seen your video for capacitors replacements to fix blinking, but aeg detail 4055407219 (display, leds and buttons PC) for my machine has only sockets for internal wiring connection and SMD components under plastic cover. Therefore I am a little lost whether it is PCB defect and what actually cause this blinking problem out of blue and how dangerous it is if i will do nothing with it. Washing machine was never in heavy use, I kept controlling filters cleanliness and detergent area. Have no electric wiring problems in the house (flat is in new house, no room lamps blinking during washing machine or dryer work, never power outages during working machines). Due to blinking, I am currently plug it out when I am not using it, but I want to keep it plugged in without blinking display as it is annoying in the darkness. Would you please give some advice what might be the problem here and whether it can be fixed without display pcb replacement Thank you very much for your help and wish you a pleasant day Kind regards

I’m having a problem with my AEG L6AMZ48FL washing machine. After the wash cycle finishes, the machine doesn’t drain the water at all, and I’m left with a drum full of water. I’ve tried running a separate drain cycle, but the water still won’t go down. I checked the filter, and it seems clean. Could there be a blockage elsewhere, or is it a pump issue? What can I do to fix this?

the problem is the dryer comes on however no power to the dryer element at all . It runs cold. All thermostats reading ok – changed main pcb , humidity probe and temp probe – no blockages . Any ideas Pnc: 914605818 00

Its spins but wont start a wash cycle . Just makes a humming sound. Checked all hoses, water pressure, changed valves in case it was a faulty valve. Someone suggested pump but I can’t get the front of the machine off. There isn’t a separate kick panel to remove as shown in some videos. Pls could you advise.