Beko WDIK754421 washing machine’s board does not correspond to the circuit diagram for this machine, it is P/N2856540100.
Board needs replacing as TRIACs and surface mount resistors that drive the inlet valves destroyed. No short found on valve coils so want to find what caused flash/bang so a circuit diagram would be very helpful for the machine or board.

I have a Beko WM5100 Washing Machine. Spin/drain missed off the program. Goes straight to the end of the program and can be opened. Separate spin/drain will do the job after a couple of tries. All items working in test mode.

I have Beko WI1573 washing machine. Removed drive belt and established that click was from motor. I will also need associated pcb for motor, but your website doesn’t recognise model number for pcb.

Brand new Beko WDEX8540430W washing machine installed without removing transit bolts drum does not turn water goes in and pumps out before fault code 13 is shown

Last week my Beko WMB714422B washing machine was running and I heard a loud pop. I had a look at the machine and the motor’s brushes, one was broken and the other was fine, a longer length. So, I replaced the brushes and then realized that the PCB board that supplies power to the motor had two tracks blown on there. So, purchased a new one. Today i fitted the PCB and ran the machine… It blew the fuse again. I pulled out the motor to examine the brushes again. On my motor housing where the brushes sit there are two position options for the brush to sit. I placed the brushes so that the flat side of the brushes are touching the contacts and not where the tip touches the contacts on the motor. I would really appreciate any further assistance n how to get the washing machine running …. dirty clothes are pilling up and wifey is not happy, so any help most appreciated. Thank you