I have a Bosch SMS58E22GB Dishwasher. Water does pump out on the start of another cycle but just before cycle finishes ‘check water code’ appears.
I have tried different cycles and some DO workon full cycle without check water code

I followed your cleaning instructions, removed a single lemon pip from the impeller. Bosch SMS25EW00G dishwasher refused to fill or work, a pump or impeller noise could be heard. I then followed your instructions to remove the impeller pump, no obvious signs or debris entangles, reassembled and the machine began a cycle, 10 mins in E25 showed again. Machine will not drain or even start a new cycle even when i drain the liquid.
Is there anyway to remove the actual impeller to inspect the shaft and see if there is debris inside the shaft?
Do i need to buy a new impeller pump or is there likely another issue?

Hi I have a Bosch SMS4HAW40G and it’s saying on the app water detected and machine has stop , I understand the workings of the hose and as in a plumber that hose can’t be the problem because if the hose was split it would stop straight away , this seems to be at the end of a program possibly with 5 or ten minutes left on the cycle , it says e61 I think in the display , I reboot the machine and it’s still there , but if I unplug the machine pull it out and raise the back it clears itself , would appreciate any advice ty

Hi on this Bosch dishwasher it seems to perform each element in a cycle correctly, except that the heating cycle does not initiate. Therefore the machine just sticks after the fill, pumping the water to the spray arms in a wash cycle, but with cold water. It does not progress further than this, so it seems that the cycle is taking for ever.
I have investigated/tested the individual components involved and non seems to be faulty. I have found that when the machine goes into this “not heating” state, if I open the door and then close it the heating cycle initiates straight away. The programme progresses to the next water heating point where it stalls again. Opening the door again allows it to continue, heat the water, and finish. Have you any idea which component might be causing this please?

Bosch Dishwasher SMS67MW00G not filling. my dishwasher starts the program but then does not fill and then stops.