Hi there, thanks for your video on YouTube regarding a teardown of a Bosch WAE24368GB washing machine. Having followed the process I have been able to confirm a broken spider on my 12+ year old machine. Given the cost to repair I have decided to buy a new machine. Do you have any recommendations on which machine to buy in terms of reliability/quality, etc. I have a budget of around £500, and would like 7-8kg capacity.
Also would you like any of the parts from the old machine (for free)? Am based near Milton Keynes if you are ever over this way.
Many thanks
Adam

We have a single parent mother and are trying to assist. She has the Siemens WM14P360GB washing machine that stopped functioning with an E43 fault which is listed as brushes.
I have replace the brushes though there was still some wear left on the old ones.
The motor will still not run in any wash selection.
It drains, fills, door opens and the timer at the end of a program still shows 1 min without a door opening and does not clear.
I do not have a test rig for the motor and have not been able to configure the wiring as yet and have found connection 3 to be for both brushes not individual brushes l and right,.
Can you advise
Thanks,
Robin

My Beko WTK92151W Washing Machine does the cycle, fills, washes, drains and then spins, like normal. After the final spin the screen just goes through it’s time adjustment. Normally it reaches 0 on the clock. The drain pump does a short final drain, the display then says end and the door lock clicks.
The screen just cycles round and the drum rotates slowly back and forth. I have to manually press the stop/start button to get it to end. It appears to be filling OK. The heater is working and I have checked the pump & drain pipe.

Hi paul I have a Beko WTB720E1W Washing Machine. The button works only if pressed in a certain way, the button is slightly wobbly but is in place.
Can you advice and supply a replacement part?

Beko WM5101W washing machine will fill, turn drum in both directions, heat water then continue to turn one way for 10 seconds (approx), pause for ten seconds, then turn the other way for ten seconds for as long as I care to let it. Up to 20 minutes before I give up waiting for a drain and refill, and press and hold ‘Cancel’. The machine immediately stops, runs the pump to empty the suds and lights ‘Spin/End’. Can you advise, please, why the machine will not follow through any wash program, and what a solution may be?
With thanks.
( I found you on YouTube and am a subscriber)
(