HI I have a strange problem with my HOTPOINT H3D91GSUK condenser tumble dryer it’s a Hotpoint H3D91GSUK and the SN: 802418003153
The dryer is just around 12 months old and the problem I am experiencing is that the belt came off and was all chewed up on the side an engineer replaced it under warranty but it shortly did it again I have replaced the belt myself but noticed its perfect when the dryer rotates clockwise but when it rotates anticlockwise the belt moves over towards the front of the machine and hard up against the guide tensioner and the ribs of the belt skip over the motor groves so part of the belt is on the flat part of the motor shaft my suspicions are on the guide tensioner being at fault but it seems ok no wear or excessive play in the bearings any advise would be very welcomed as it makes no sense to me at this point lol
Kind regards James

I have found the thermistor on the heater assembly is open circuit and require a part number to order it, all other sensors throughout Bush TDT17CN Condenser Tumble Dryer seem ok including the other 2 trips on heater assembly.
The only numbers on thermistor are NTC06008. 001. And TP 2346, Regards, Colin

Hiya mate – you helped me repair my mother’s condenser dryer not long ago with an amazing video that was so detailed that I bought your a beer. Now i have an issue with my own John Lewis JLTDC01 Condenser Tumble Dryer where the belt has broken i think – do you have a video that might cover this model? There might be afew more beers in it for you!

I have a Whirlpool DELX 80113 Condenser Tumble Dryer. I finally got the drum off and moved back, but I need to see how to get the belt on the motor spline , and how to track it properly. I can’t find a video for this model, so I am in the dark

the dryer is a hotpoint Ultima CDT80 reverse action the front panel screen has gone don’t know where. It was comming and going when on the machine worked.
This continued for some time, I had to leave it on for a short while the the screen came back and all was well.
It looks like it needs a new one would this be available economical and would it have to be programmed. Many thanks like the youtube info.