Hi , seen your YouTube and was wondering would you have any info to help me fixing my washing machine it’s only 2,5years old
Beko wtk82011w
It won’t do a wash cycle it starts and stops about 5 seconds later the water only goes into the drawer on top for the conditioner
It will do a spin and drain cycle and a drum clean cycle and and rinse cycle
I have emptied the filter and cleaned it
Any help at all would be appreciated thank you so much

My Beko WTK92151W Washing Machine does the cycle, fills, washes, drains and then spins, like normal. After the final spin the screen just goes through it’s time adjustment. Normally it reaches 0 on the clock. The drain pump does a short final drain, the display then says end and the door lock clicks.
The screen just cycles round and the drum rotates slowly back and forth. I have to manually press the stop/start button to get it to end. It appears to be filling OK. The heater is working and I have checked the pump & drain pipe.

Hi paul I have a Beko WTB720E1W Washing Machine. The button works only if pressed in a certain way, the button is slightly wobbly but is in place.
Can you advice and supply a replacement part?

Beko WM5101W washing machine will fill, turn drum in both directions, heat water then continue to turn one way for 10 seconds (approx), pause for ten seconds, then turn the other way for ten seconds for as long as I care to let it. Up to 20 minutes before I give up waiting for a drain and refill, and press and hold ‘Cancel’. The machine immediately stops, runs the pump to empty the suds and lights ‘Spin/End’. Can you advise, please, why the machine will not follow through any wash program, and what a solution may be?
With thanks.
( I found you on YouTube and am a subscriber)
(

Hi I have a Beko WTB741R2A Washing Machine. I’m looking to possibly replace the motor and PCB board of this washing machine. From Saturday (21st Dec. ) it started tripping my electrical fuse box while running a “dark care” cycle. It completed the cycle but when I went to use it Sunday the machine would only fill with water and the drum would not spin. On further research I found it had an E11 error code and further research from your video on this code leads me to believe I require a new/second hand refurbished motor and the accompanying PCB Board as explained in your Video. Do you currently have such items in stock? Many Thanks, Noel Warn