Hello. My Hotpoint FDYB 11011 P dishwasher lights up “Low Rinse Aid indicator light” before the start. Then it starts filling water and spinning the fins. After about 30 seconds it starts pumping the water and the cycle stops. At the same time, the two salt lights and low Rinse Aid indicator light.

Hello Paul i hope you are well and had a good w end 🙂
Just an update on the Hotpoint LBT4B019 integrated dishwasher. I took it apart at the w end and all seemed to check out ok. The heating element had good continuity and read 32 ohnms. The motor had a resistance reading of 32 ohms which i thought was ok as it has a mass of coil windings.
The motor when taken off the heater and cleaned i found that the impeller shaft had a lot of play in it as though the housing bearing had collapsed but im not sure if this is how it should. When the motor was together and i spun it it spun freely well spun free for half a turn then went tight and seemed notchy ( like a spring was being released) but i think this may be how the motor works with the magnets around it?
i took out the spray arms and the spray arm feeders,cleaned them and found no real blockage.
I cleaned out the return hose that again didnt seem to bad.
i removed the inlet water pipe and checked the filters in the hose and the machine inlet filter but they were fine.
i checked the pressure switch (the rubber hose that goes from the switch, up the side of the machine and attaches to the base of the sump. I blew through this rubber hose when disconnected and it was clear. I tested the contacts in the switch (open circuit at rest, when i blew through the switch there was continity)
im not sure where to go now other than buy a new machine as the cost of repair is really not worth it with the cost of a nearly new machine and then something else may fault with the repaired machine.
Do you have any advice of where could go and check or what to check?
i havent taken out the clear bottle at the side of the machine as that means the whole side coming off which i dnt mind doing.
i will attach a image of the machine what it shows when it faults.
I can not find any information about what this sequence of lights mean when they illuminate and the machine stops
The power light flashes very fast and the eco light (led 1) and the normal wash cycle (led 3) illuminate straight and stay on constantly (they do not flash)
My owners manuel doesnt show any meaning to this and no where on the internet shows a hotpoint with these lights showing and then an explanation.
I know you said that the info on hotpoint can be a bit hit and miss.
If i try 5 times to run a cycle it will fail 4 times but work on the 5 and perform with no faults
kind regards
matt miller

Indesit DIF16UK dishwasher stops after 40 mins in Eco mode and about 6 mins in the timed mode. Led lights 1, 3 and 4 keep flashing. The pump keeps draining until turned off. Any help will be appreciated. Thank

Do you still have a heating element for this Indesit Dishwasher IDS 105 please?
I can not order the one you have under the SKU=B64A-C00256527 for £22.00

Zanussi Dishwasher ZDF14011WA heater does not heat water or air drying. Have checked continuity of heater and changed the relays on the control board. It would appear to be a thermostat fault (not on the heater unit itself). Could you please help me out to solve this issue?