You can refine your search further by entering make and model number if you are looking for parts. If you are looking for tutorials please use appliance type only. If you need help please use FAQs or ask a question in contact us page.
Having trouble with layered Navigation? Watch Video
February 11, 2021 
Hi Paul I am thinking of buying a new Bosch serie 4 washing machine could you please tell me if the current Bosch model washer WAN28281GB has a replaceable bearing and is not the sealed type. Thank you
January 26, 2021
Looked at Pauls Video and need to replace carbon brushes. Links on your page point to other stores. Any recommendation for replacements? One site give model number but brushes in photo are not angled.
January 25, 2021
Timer showing 1 minute but still washing/going around will not stop
January 25, 2021
After fitting the original Bosch drain pump, following your tutorial, I connected up, but as soon as I turned the rotary program dial for a rinse, it seemed to not want to do anything, then lock failed, finally lights went out on the control panel.
Removed the control panel and there was a decent amount of black smoke stain around a coil, cleaned the boards up a little, but cannot get a reading for for this coil and a couple of resistors close by. 13 year old machine, little used. Is there a likely connection between the two faults, or is it just bad luck? where does one get coils etc for repairs?
Kind Regards
I will try and help with your Bosch Washing Machine WAE28162GB/05 problem.
This sounds like you created a short on the machine and have blown the printed circuit board or PCB the best way for you to move forward is to find a second-hand PCB using either your model number or you could use the part number in the exploded diagram below to find the part
January 25, 2021
Pulled out motor and replaced both motor front and rear bearings.[Motor had a seized rear bearing and the machine stopped turning one day.]. Everything else was fine.
Put motor back in, and now on wash or spin everything looks fine but the electric motor spins for a second or so and stops – this happens on wash and spin!? Drain works fine. Wondering if when the motor seized it caused some other issue with the motor, PCB or even the suppression capacitor. Nothing visually obvious and no smells or sounds, though I haven’t taken the PCB out to have a look? Tacho, stator/armature windings, PCB? Stumped. Can you help?
October 20, 2023
If your washing machine has a leak or the seal has just gone mouldy with black marks on it then you might need to replace it and fit a new oneTo order your door seal you will need your full model number. (This is normally around the washing machine door frame on a sticker) If
