HI PAUL THANKS FOR YOUR PROMPT REPLY TODAY SPENT SOME HRS TODAY TRYING TO FIND FAULT
1 CHANGED FILTER WITH SPARE I HAD FAULT STILL THE SAME, REFITTED OLD
2 REMOVED DOOR SWITCH
CHECKED OK, REFITTED
3 RECHECKED ALL WIRING AND PLUGS ALL SEEM OK
THIS IS WHAT I THINK
I SET MACHINE TO DRAIN
PUMP ON OK, PANEL SHOWING SPIN LIGHT ON
BUT NO MOVEMENT OF DRUM, EVEN WHEN I HAD PROGRAM SET TO 15 MIN WASH IT FILLED STARTED
AGITATING OK HEATER HAD 240V THEN WHEN I THINK IS WAS SUPERPOSED TO SPIN the WHOLE MACHINE SHUT DOWN, THE ECO SILENT DRIVE HAS An INVERTER
IN A BOX AT BOTTOM
I HAVE NOT HAD IT OUT YET BUT WHAT DO YOU THINK IF THE MACHINE CAN’T SPIN WOULD IT SHUT DOWN OR JUST SETTING PROGRAMMER TO A SETTING THEN AFTER 30 ODD SECONDS MACHINE SHUTS DOWN IS IT CHECKING THEN FINDS A PROBLEM WITH INVERTER OR MOTOR AND SHUTS DOWN? BUT NO-FAULT CODE OR PERHAPS THIS MODEL DOES NOT HAVE A FAULT CODE FOR INVERTER? IT IS NICE TO HAVE SOMEBODY TO ASK ABOUT THE PROBLEM
I RETIRED BUT BEN A MAINTENANCE ENG ALL MY WORKING LIFE
MANY THANKS BOB FRI 21.50

The machine used to be able to spin dry a heavy load. It still can spin dry a lite load. Thank you for your help. Paul daniels

Hi, can you advise if there is anywhere I might be able to obtain a new bearings/armature repair kit or spares for the motor as it’s seized up?
Thanks in advance.

My motor still runs but now believe the tacho is broken (open circuit) which I’m assuming means replacing the motor. Can you help me locate a second hand motor because as to say in your youtube videos a new motor is to expensive. Thanks

Motor seized up (had been noisy for several weeks)! Replaced both motor bearings (rear one had partially disintegrated) – bit tricky using a puller to remove them!
All put back nicely, but motor now turns once or twice and then stops! Water goes in, water pumps out – no issues. If it’s on wash, or rinse, or spin everything seems fine, but when the motor has to turn it only turns once or twice and then stops? Is it the motor (commutator or coils) – need a new motor, or potentially could the PCB have suffered damage originally when the motor seized? Controls and everything appear fine, it’s just that the motor starts but then can’t continue!