You can refine your search further by entering make and model number if you are looking for parts.
If you are looking for tutorials please use appliance type only.
If you need help please use
FAQs or ask a question in contact us page.
Having trouble with layered Navigation?
Watch Video
Hi Paul TDWSF83BEP Door Filter Light
Im looking for a little assistance into a tumble dryer fault please and the spares i may need. The door filter light comes on, if you push start machine comes back on again but then soon cuts out again with the red light on. So i have investigated and the following has been done.
Tumble dryer does get warm but keeps cutting out with red door light.
I dismantled door filter and cleaned any lint debris from filter and duct.
I removed condenser and cleaned under tap as per instructions found online.
I removed right side of machine and found lint under the NTC sensor by fan motor, removed this lint as thought this was problem, but machine still does the same.
Opened covering here as well and cleaned any lint from here, only minor.
Removed rear heater to look to see if heater had any lint, but hardly any found.
So tested the sensor on top of heater and the thermal fuse, thermal fuse has continuity and sensor has resistance circa 18k Ohm that reduces when warmed as expected, heater tested (not expected faulty as was getting warm) and both coils ok.
tested sensor by fan motor (NTC?) and again this has a resistance and reduces with warmth.
So I inserted a thermocouple close to the two sensors at top of heater to see what was going on and when you start machine it appears to turn heater on which rises to circa 250 Deg C this then reduces down to circa 30 Deg as fan cycles air through. It tries again to heat and it goes to circa 340 Deg C but then stops and lights the door filter light.
Removed and reinstalled connections to pcb by selection knob but no different.
I guess the thing is cutting out because it thinks blocked by lint and overheating but sensors appear to be ok,any help with spot where my thoughts are wrong please and what to test to understand what i need to purchase to repair?
Thanks V Much
Kevin
Hi Trevor this is the right element for your model listed below. just click on the picture. there is genuine and pattern available make sure you hoover out the machine while you are doing the job as it helps a lot with maintaining the machine.also fits any of these candy models GO C 21880, GO C218/180, GO C58F80,
How to Clean a Tumble Dryer Condenser Box Unit In this guide, we will explain how to clean the condenser box in your condenser tumble dryer. This guide applies to all brands of tumble dryers, including Electrolux, Zanussi, AEG, Hotpoint, Creda, Ariston, Beko, Bosch, Neff, and Siemens. Keeping your condenser box clean and efficient can
Condenser tumble dryer are relatively easy for most people fix if they are reasonably competent in DIY and working with electrical products as they really are rather simple appliancesThis video can be used on all these makes of Condenser tumble dryerAEG, Arthur Martin, Castor, Corbero, Electrolux, Elektro Helios, Faure, Hansa, Husqvarna, Lloyds, Marijnen, Privileg, Rex,
The first thing you will notice if your tumble dryer belt has snapped, is the dryer is making a motor noise but the drum is not turning or the dryer is not drying. If the drum in your dryer is no longer rotating the chances are that your drum-belt may have snapped, you end up
Beko Condenser Tumble Dryer How to Repair Beko Condenser Tumble Dryer? Ultimate Repair Guide for Tumble Dryer Leaking Water We will fix your problems in this repair guide for Beko condenser tumble dryers! Whether you’re experiencing issues like a persistent water tank light, leaking tumble dryer, or simply want to ensure optimal performance, this guide […]
March 14, 2019 
