Beko CSM81320DX cooker, oven dials not working
Turn oven selector switch to which mode is required than adjust the temperature, but nothing happens no fan or heating
- Published in
Zanussi ZKC6020W Top oven won’t heat up
Have replaced element also temperature gauge in oven which goes to a double fitting switch. The grill works but it takes the top oven over 30mins to get to 150 degrees. Do you think the front part of the switch could be the problem. If so where would I be able to purchase 1. Thanking you.
- Published in
AEG DC4003020M Competence Fan oven not heating
Hi,
My fan oven is not heating up. The fan comes on as does the thermostat and internal light but no heat.
The main oven does heat up when we put it into conventional oven mode.
Any suggestions very much appreciated
- Published in
Hotpoint HAE60KS 60cm Ceramic Hob Double oven not cooking correctly
Hi, I wonder if you can offer advice on the cooker we have, it’s not cooking properly in the oven.
Many thanks
Sue
- Published in
Hotpoint UHS53X Main fan and element not working
Top oven/grill is OK, timer, thermostat all seem to be working OK, just bottom (main) oven a problem. Fan isn’t jammed (finger spins OK). No heat either!
- Published in
Logik Lftc50w12 Oven not working
Oven not working, the grill and rings do work,light does not come on when turning nob on to the oven, many thanks..
- Published in
Stoves 600 DFDOa cooker the Oven Stays on when turned off
My oven stays on sometimes even when I turn selector switch off. Can only turn off by switching off at mains and back on again, then stays off. Thermostat seems to work correctly while cooking turning neon off and on to maintain temperature. When turning off fan stops working but after an hour of so it still feels warm at the back of the oven, and maintains that warm to touch feeling all night. Is this likely to be the main selector switch? There must be a relay that is stuck on and is only corrected by power off at mains. And advice and can you provide part for my model
- Published in
Whirlpool AKP490/WH Oven Needs new element
The oven turns on but there’s no heat. The grill works.
The problem is, the screws to replace the panel at the back of the oven (inside) are complete rusted and don’t budge. I’ve opened the back and it doesn’t look like it’s accessible from there.
Any help is much appreciated.
Thanks in advance!!
- Published in
Zanussi ZOB330X Oven keeps tripping the circuit
Hi,
I have a Zanussi ZOB330X electrical oven and when it is switched on it begins working for 1-2 minutes & then trips the circuit.
After reading some of your oven fault diagnosis articles I found that this maybe due to the elements in need of replacement. I therefore replaced both elements which I could see had suffered some warping. These new elements now both work as can be seen in the short time the oven works however it still cuts out after 1-2 minutes. What could be the reason?
Any help would be appreciated. Many thanks
Ossie
- Published in
Beko double oven Bdvc668w Keeps tripping out
- Published in