Hotpoint Dishwasher FDM550P with the Start/Pause and End leds flashing.
Hi
I have a Hotpoint Aquarius FDM550 with the Start/Pause and End leds flashing. I am wondering which fault it is and what is wrong and what I need to buy.
Thanks in advance,
- Published in
Hotpoint Dishwasher FDAL28P Flashing lights, not completing cycle
Good morning. I purchased this machine second hand. The machine is filling and you can hear the motor running and draining bit it only lasts around 10 minutes. Then the on/off, start/pause, wash and end buttons all flash. Thank you
- Published in
Hotpoint Dishwasher LFT228AUK code 13 flashing
Re: Hotpoint LFT 228 A UK
When off, the machine comes up with flashing code 13 and I think a pump is trying to run and there is hot water in the base under the filters. I have to switch it off at the mains. My wife wonders if she spilt water by the controls as it was fine until she was cleaning the sink above…. any thoughts please?
- Published in
Hotpoint Dishwasher FDM 550P.R Flashing lights
My Hotpoint FDM 550 P .R (Serial No.36563960000) dishwasher has a fault. It seems to only happen on the Normal programme, not on the Fast or Intensive programmes.
The fault is that the Salt, Rinse aid and start pause lights flash rapidly. (no other lights flash)
We only find this fault when we go to unload the dishwasher a couple of hours after starting the programme so it may well have started flashing in the middle of the programme.
The machine seems to wash OK and when we open the door the interior is nice and warm so drying is OK too.
I have checked to make sure hoses are not trapped or kinked.
Thanks
- Published in
Hotpoint Dishwasher LTF8B019UK Fills then empties flashing 05
- Published in
Samsung xw1706079 slimline dishwasher error 4c
I have samsung dishwasher and after about 2 minutes of running it comes up with error fault Code 4C the label on front has worn but there is this number on the back
samsung dishwasher xw1706079 0047
- Published in
Indesit DIF04B1 dishwasher Power light flashes green and LED 1 and 3 stays on.
Not sure what the problem is. Over the last few days it has not finished cycles water droplets still on the plate sometimes it heats and sometimes error. Pulled it out and moved hoses and it worked for a day but now errors again.
- Published in
Bosch Dishwasher SMS58N68E door wont stay open and falls down
My dishwasher door falls down when trying to open the door, it falls into the open wide position, iam frightened the door can get additional damage, so it must be held while opening. The bad thing is that with such breakage, the door cannot be left slightly opened to allow the dishwasher to dry after the program is finished.
- Published in
Bosch SL15N1b dishwasher leak from water matrix into right angle elbow joint
HI,
In the picture above, on the bottom left corner of the red/black box in the centre of the image, (with the play button in) there is a right angled elbow. Mine is leaking. Can you tell me what this is called so I can find a new seal for it please…. This is the only machine I can find on you tube that looks like this.
It is A bosche SL15N1B or SG145E16GB/29
Thanks
- Published in
Hotpoint DWL-DEA603-S Dishwasher Starts a cycle then stops after 3-5 minutes.
On/off, salt/rinse aid leds flashing, washing led steady on, drying led off, end led on, start/pause off.
Can you help please?
- Published in