my tumble dryer is not heating it is turn on the drum but there is no heat coming out to the machine could you point me in the right direction, please

Can’t find a single capacitor for said machine!

Hi there. I’ve worked out how to enter the diagnostic mode on this model. I wonder if you could help me interpret the info I’m getting from the display.

I’m assuming that NT:01 & NT:02 are the NTC thermostats. NT:01 probably in the door and NT:02 probably on the heater.

I’m getting a reading of 19 from NT:01 which I assume to be degrees centigrade and is about right for the kitchen. However NT:02 is giving 1:20 which I assume to be 120 degrees C.

If thats the case then of course it won’t heat up for safety reasons.

I can’t find anything online regarding this model maybe because it’s still the current model on sale in the shops although I’ve had this one three years already.

I’m happy to admit my assumptions are wrong regarding the display. If you can find out any more about the test mode on this machine that I’d be very grateful!

Cheers, Paul

As per your instruction video, I need to replace the MSC.
Can you please tell me which part I need, the cost and when you can deliver.
Thank you.

Digital lights flashing Displaying error code 15, dryer still working

Hi-my tumble dryer has the fault described above: all lights flashing and then it stops. I suspect it is the heating element(s). How much would it cost me to fix it all in? – Thanks

Wife used it, worked fine, next time just completely dead. PCB712529-02. I am an engineer, can read schematics, should be able to repair this if I can follow the circuit from power supply onwards, would be nice to get the schematic / circuit diagram. Can you help please? Regards
JD

iv cleaned all filters but still not working

Hi please can you help ive been watching your videos now for past 2 weeks as i have a hoover condenser dryer that has stopped working but it hums still. Its been playing up for a while now but its only 3 years old and only used every 2 weeks so done hardly any work.up to now i have been turning the drum with clothes in so they have been sitting high to the right as thats been the only way to get the drum going but now it does nothing but hum. I have taken the top off and switched on and then just gave the drum a little help and its ok and on stopping i help again and off it goes so i think its the capacitor. I have now removed all the front apart from bottom part. i can see the capacitor but i scared to remove as it says you can get shock. i dont really want to remove the drum i can undo the capacitor easy for removal but can i touch the main casing of the capacitor is it just the connections you must not touch and can it be discharged with connections on please help

Hello! I have tested the two thermostats at the back and the sensor at the front (according to your excellent video) and they seem OK. How can I tell if the problem is with the circuit board? The machine is eight years old but hasn’t had a lot of use.