FORGOT YOUR DETAILS?

AAH, WAIT, I REMEMBER NOW!

Candy GVS C9DCGB-80 condenser tumble dryer E22 error code the fault is it stops after a few secs

by / Wednesday, 30 December 2020 / Published in

Stops whatever cycle after less than 30secs with E22 all lights flashing alarm. Have followed your videos and have continuity on safety thermostat but I don’t seem to have continuity on the other one, but I don’t seem to have a link cable. Tried continuity by taking off each wire but still nothing. Can’t find this part on spares websites.

Chris Dix

Paul answers

I will try and help with this problem Candy GVS C9DCGB-80 condenser tumble dryer

there are three thermostats on this machine two of them are on the heater a 206c cut out thermostat, I am not sure if the one next to this is an NTC sensor or it is a cycling thermostat, then there is one at the front 443 in the diagram. If all of these are in good condition you need to test the heater. it has two sides to it a high and low side you should have an ohms reading on both sides of the element to match the wattage. the other common problem with these tumble dryers are the circuit board relay. you can find out all about these in the videos below I hope this helps you identify the problem with youre tumble dryer 

 

 

 

If you want to support the site please mark us to your favourites, also I would be grateful if you would subscribe to our social media channels as this really helps my site and keeps us going.

YouTube. http://www.youtube.com/user/howtorepair
Facebook. https://www.facebook.com/how.to.repair.appliances
And if we really helped you save money you can always click on the Buy Paul a Beer page

 

If you need any further assistance please feel free to contact me​. all the best Paul​.

photo  
Paul Charmbury
Appliances Engineer
youtube facebook google+ beer

Candy GVSC9DCGB-80 condenser tumble dryer fault codes and errors

 

Presently available error codes for the SKYLANDER models range

 

Cuore NFC electric module

ERROR CODE MOST PROBABLE REASON FOR THE ERROR CODE

 

E03 Tank is full of water and has to be emptied.

E05 Front NTC sensor is either short circuit or open circuit. Check front NTC sensor and/or

wiring.

E07 Alarm, filter occluded, This error can only appear after the end of a cycle. The filter is

occluded because of fluff presence, the correct ventilation is not allowed. Clean the filter.

E08

Thermo fuse intervention. Replace the thermo fuse and check that ventilation circuit is

clean, check the wiring.

E10 Missing communication between "Cuore" Electric Module and Display Electric Module and/or

Wiring.

E11

In the rear part of condenser the temperature is too high. Check that all ventilation ducts

are clean, check that ventilation system is working well. Check the condenser, the motor,

the fan could be broke/blocked.

E12 Pressure switch doesn’t work. Check the pressure switch and/or wiring. Check that the air

trap is clean.

E13 Compressor NTC Probe is either Short Circuit or Open Circuit. Check the compressor NTC

probe and/or wiring.

E14

Rear NTC Probe is either Short Circuit or Open Circuit. Check the rear NTC probe and/or

wiring.

E15 Main board not programmed. Program the main board.

E19

It is not possible to use NFC tag for any actions until the next POWER ON/OFF. (switch off

and switch on)

E21

Heater control relay on the “cuore” electric module is not working. High temperature has

been reached – Thermo Fuse worked. Check the thermo Fuse, and the wiring. Check that

both the ventilation circuit and ventilation ducts are clean and duct is not obstructed.

Replace the “cuore” electric module only in the case that the heater command relay is

faulty.

E22

On none compressor type this may be heat related

Compressor control relay on the “cuore” electric module is not working. Check the

compressor and compressor wiring/connections. Replace the “cuore” electric module only

in the case that the compressor command relay is faulty

Match your part for Candy GVSC9DCGB-80 condenser tumble dryer and the use reference number in list below and click on the link to your part

Reference Part Number Description
10 41041747 Timer/select. knob
31b 40010967 Control panel with Sensor
48 40010971 R/H side frame
48a 40010972 L/H side frame
49 40005333 Top rear frame
51 40005221 Work top
60 40009145 Hinge
63 40005026 Door glass
67 40009945 Door with trim
77 40004062 Rear panel
79 40002885 Foot
82 40009197 Door panel
88 40009335 Front panel
131a 92470020 Hose clip
135 40004935 Water valve
136 40004933 Water container valve
152a 40010223 Light guide support
153 28375043 Pressure switch
156 41039164 Capacitor 7 MF
157 40011135 Harness
164 91200489 Anti jamming filter radio
171 40008460 Main motor
202 40009120 Drum
202 40011928 Drum
202 40016169 Drum
205 40006362 Drum shaft assy
218 03210179 Bearing
219 21446068 Bolt
225a 40009928 Gasket
229 24721202 Circlip
230 40004306 Bearing clamp
271 40005393 Door gasket
292 40001012 Drive belt
318b 49039504 Electronic control PCB - NFC -Programmed
318c 40010594 Electronic NFC pcb - Not programmed
442 40009278 Fan
442a 40009379 Rear fan
443 40011108 Thermostat
448 40005010 Heater
448 41042962 Heater
448 40013366 Heater
448 40015910 Heater
461h 41014595 drying probe seal
491c 91200201 Mains cable x UK
494d 40010222 Light Guide - Digital Display
520 40006928 Door coupler
631 03730696 Stopper
643a 40009280 Handle insert
647 40008382 Water condenser
657 41018444 Bracket
671 03610428 Washer
690 40006246 Rear sealing felt
690a 40004577 Rear cover seal
690c 40010756 Seal motor/water duct
696 40006820 Heater support
697 40003226 Heater support disk
706 40010766 Front ring assembly
707 40005584 Filter for carter
727 40004816 Gasket
728 40006251 Gasket
734 40007503 Container
738 40004817 Gasket
745 40009339 Kickplate assy
755 40007362 Cover
755a 40007506 Fan insert
756 23715194 Spring
757 40003315 Gasket
763b 40003319 Water rear duct gasket
763d 40004811 Reservoir top cover
763d 40010627 Reservoir top cover
764 40004815 Gasket
766 40006390 Water container assy
777 40004157 Heater gasket
797 40004610 Beltightening pulley
799 40001026 Belt tighteningb spring
806 40009170 Upper hinge sleeve
807 40009171 Lowen hinge sleeve
819 40009121 Drum scowel
822 40009346 Innerdoor assy
826 40004091 Door hook
835 40004307 Drum support wheels
840a 40008358 Floating
840b 41041353 Microswitch
998a 40010974 Eeprom File NFC
999 41045070 Electrical diagram
1017 41022106 NTC probe
1026 40007831 Front felt

full list of spare parts for this model below

Our How-to-repair stores

Current page 1 Total pages 0

  • Hoover Washing Machine Mains Cable - UK Plug

    Category: Recycle Appliances

    £19.95

  • Candy Hoover Tumble Dryer Heater 40015910 240V 2100W

    Category: Recycle Appliances

    £42.85

One Response to “Candy GVS C9DCGB-80 condenser tumble dryer E22 error code the fault is it stops after a few secs”

  1. Martine Snooks says : Reply
    April 27, 2022 at 4:45 pm

    I can found my heater on no website. Model GVS C9DCGB I only need the heater not element. Its Candy Hoover thank you if you can help

24h technical help answers

Questions on faults in the comments will not be answered. Please use the contact us form instead.

TOP