How to replace Electrolux Washing machine pump that will not empty.

by / Wednesday, 26 March 2014 / Published in Pumps, Repair Guides, Washing machines




How to replace Electrolux Washing machine pump that will not empty.

Washing Machine Pumps

If your Electrolux or John Lewis Washing machine will not empty then this video will help you.
To order your washing machine Pump you will need your full model number (This is normally around the washing machine door frame on a sticker)




 

 

If your Electrolux or John Lewis Washing machine will not empty then this video will help you.

This tutorial will show you what to do if the Electrolux or John Lewis washing machine does not drain or empty the water out, this repair was done on Electrolux 8kg washer dryer appliance.

After checking that the Electrolux pump is faulty in our previous tutorials you will need to replace the old washing machine pump with a new one.

Disconnect the appliance from the electricity supply by removing the plug.

You have two ways that this can be done, you can replace from the bottom of the machine if there is no base plate fitted, or you can take the front of depending on your model.

Once you have gained access to the pump you will need to remove the hoses from the pump by undoing the clips, which will be one of two type jubilee type or clapped type.

Disconnect the wires that are attached to the pump and take note of which terminals they came off. (Taking a photo is always a good way).

You will need to remove the bolts or clips that hold the pump in place.

You will need to follow previous steps to replace the new Electrolux pump.

2 Responses to “How to replace Electrolux Washing machine pump that will not empty.”

  1. Ricky Powers says : Reply

    Hope it works. Thanks

24h technical help answers

Leave a comment below or click the banner above to ask your own question.

TOP