I have a Beko DTBP10011W heat pump tumble dryer and need to buy a new capacitor for the drum of my Beko 10Kg since it is not turning without a little push. Can you please help? deon burgess Hi Deon, sorry to hear about your problem with Beko DTBP10011W Heat Pump Tumble Dryer, If your […]

HI I have a strange problem with my HOTPOINT H3D91GSUK condenser tumble dryer it’s a Hotpoint H3D91GSUK and the SN: 802418003153
The dryer is just around 12 months old and the problem I am experiencing is that the belt came off and was all chewed up on the side an engineer replaced it under warranty but it shortly did it again I have replaced the belt myself but noticed its perfect when the dryer rotates clockwise but when it rotates anticlockwise the belt moves over towards the front of the machine and hard up against the guide tensioner and the ribs of the belt skip over the motor groves so part of the belt is on the flat part of the motor shaft my suspicions are on the guide tensioner being at fault but it seems ok no wear or excessive play in the bearings any advise would be very welcomed as it makes no sense to me at this point lol
Kind regards James

Hiya mate – you helped me repair my mother’s condenser dryer not long ago with an amazing video that was so detailed that I bought your a beer. Now i have an issue with my own John Lewis JLTDC01 Condenser Tumble Dryer where the belt has broken i think – do you have a video that might cover this model? There might be afew more beers in it for you!

I have a Whirlpool DELX 80113 Condenser Tumble Dryer. I finally got the drum off and moved back, but I need to see how to get the belt on the motor spline , and how to track it properly. I can’t find a video for this model, so I am in the dark

Hi Paul.
Great videos and very clearly presented.
Want to replace belt on my John Lewis JLTDH21 heat pump tumble dryer but not sure on easiest way. After top and sides off, is removal of front or back easiest for getting new belt on? Also missing the pulley tensioner circlip. I can probably find a replacement, but wondered if there’s any bush or spacer that might also be missing (and now inside my hoover)? Does the pulley wheel have quite a bit of float on its shaft?
Many thanks.
Julian