We have a single parent mother and are trying to assist. She has the Siemens WM14P360GB washing machine that stopped functioning with an E43 fault which is listed as brushes.
I have replace the brushes though there was still some wear left on the old ones.
The motor will still not run in any wash selection.
It drains, fills, door opens and the timer at the end of a program still shows 1 min without a door opening and does not clear.
I do not have a test rig for the motor and have not been able to configure the wiring as yet and have found connection 3 to be for both brushes not individual brushes l and right,.
Can you advise
Thanks,
Robin

Hotpoint WM63 washing machine fills and goes through the motions until cycle ends. Motor doesn’t move, it tried to or twitched a little at one point after I renewed the brushes. The commutator is smooth I’ve cleaned it with alcohol. The brushes make contact with the commutator(?). I’m at a loss currently.

Hi paul hope you are ok. I have zanussi zwgb7160p washing machine. It shows me an e10 error during a wash cycle. I also think I may need a motor brushes. Could you please help me? I will drop additional info below, cheers!

NIDEC motor
Type 20584
(ERROR CODE E 10)
(Machine manufacturers
29/03/2013)

My Kenmore 110.24942300 washing machine’s motor starts, and agitates (or spins, depending on selected cycle) runs a short while then stops. After resting, will restart. Has tripped the circuit breaker once. Could the motor be overheating and tripping a thermal switch? Is it possible that the centrifugal (starting) switch is not cutting power to the start winding? Thanks!

Beko WMP652W washing machine stopped working and tripped electric.One of the segments on the commutator has lifted, cleaned commutator and its in good condition,apart from the one segment, washer is still working, but motor is clicking due to raised segment. Would you have a used, working motor to sell and how much would it be please. Thank you