dOF fault on display ,could not get any programmes to work now machine won’t switch on at all.

I have just seen this video after fixing my wf321p earlier with this exact fault. I have to ask though about how you have fitted the electrolytic capacitor on this board. I can see the polarity before you remove the faulty capacitor and the markings on the board are a white circle and a + which both show the opposite that you refer to as “positive on the left” as the +ve is clearly marked on the board to the right. The white band marked -ve on the capacitor can be seen before removal and is nearest the small 8 pin I.C. adjacent to the capacitor being replaced which is the white circle on the board. I have a photo of mine before removal which also shows this. Basically, it looks and sounds to me as though you are fitting this capacitor the wrong way round. The link below also shows the capacitor with the -ve side nearest the ‘chip’ and “on the left where the little white dot is”. Electrolytic capacitors fitted the wrong way round don’t usually last very long and can ‘go’ in style as it were.

Metal sensor strip caught up in clothes & snapped off.
How can I gain access to attach a new one. Do you sell the part I need? Does one end attach to a spade connector?

Followed the video the thermostat seems at fault no circuit
Coil reads about 45 ohms
The dryer light indicator doesn’t light when put on the program cycle?
Would that be the thermostat cut out at fault?
When measuring volts on coil I get about 76v

Machine will wash and rinse but when it comes to spin it beeps and gives fault code 08

Towards the end of a bed/bath cycle the machine stopped and all the cycle lights / power light flashed rapidly. I opened the door and washing was dripping wet and possibly not completely rinsed. I set it to a rinse only cycle, that started ok but then went to flashing again. The doorlock light has stayed lit. I set it to spin / empty and it won’t start. Now the machine won’t unlock and it looks like the drum doesn’t spin. I’m going to try opening the pump pre-chamber and see what happens. Hope you can help (again). Thanks.

Hi Paul – my tumble drier is taking ages to dry but it has stopped collecting water in reservoir – it is bond dry. The condenser is wet so something is wrong. The condenser is cleaned regularly. Any advice – I will definitely buy you a pint if you can help. Thanks Lorraine

The water drawer has barely any water in it when I use the dryer, there is water coming out from below a sponge at the bottom at the back. I live in Kearsley, Bolton so wondered if I could get the part to fix it from you as I know you’re local and have found you via YouTube. I emailed yesterday and called several times but the line is constantly engaged.
Kind regards,
Melissa

Hello. I need to find some thermostat for my dryer mentioned above.

Could you help in locating were to buy from as I am finding it difficult to find some for model no tdwsf83bep. Thanks.

My Hotpoint FDM 550 P .R (Serial No.36563960000) dishwasher has a fault. It seems to only happen on the Normal programme, not on the Fast or Intensive programmes.
The fault is that the Salt, Rinse aid and start pause lights flash rapidly. (no other lights flash)
We only find this fault when we go to unload the dishwasher a couple of hours after starting the programme so it may well have started flashing in the middle of the programme.
The machine seems to wash OK and when we open the door the interior is nice and warm so drying is OK too.
I have checked to make sure hoses are not trapped or kinked.
Thanks