Lamona LAM8670 Dishwasher Doesn’t seem to heat up for the cycle or dry the dishes
I’ve watched some of your videos, does the same heater do the heating for the wash cycle and the heating to dry the dishes? Can you please offer any advise and any spare parts I might need? Thanks.
Jamie Kemp
I will try and help with this problem Lamona LAM8670 dishwasher
Hi Jamie I do apologize for the late response but iam overloaded with the number of questions coming in. you will need a multimeter and you will need to gain access to the bottom of the machine to the heater you need to test the heater on the plug fitting as the element may be still in good condition but the thermostat may have blown, if this is the case you will need to replace the whole unit they're not that expensive and I have put a link to the correct heater for your dishwasher and also a couple of useful videos to assist you with your repair
Hi there, have a Lamona LAM8605. Not getting hot anymore.
Have checked the heating element, continuity across the two pins is ok. Ohm reading of just below 25.
Is there anything else that this could be?
I checked the main controller board in the door. Nothing obvious here but not sure how to check this one.
Please help
I would be inspecting the wiring that runs through the door that none of the wires are broken due to metal fatigue where the door is opening and shutting regularly. it is also possible that the relay on the circuit board may have become faulty or you may have a faulty NTC sensor or thermostat that is not telling the program to send power to the heating element