Dishwasher constantly draining Balay, Constructa, Kuppersbusch, Neff, Siemens, Tecnik.

by / Monday, 08 September 2014 / Published in Dishwasher, Repair Guides, Water Systems & Valves




 

Buy Dishwasher Parts

Balay, Constructa, Küppersbusch, Neff, Siemens, Tecnik dishwasher keeps emptying and filling, how to diagnose the fault and replace the parts.

 

 

Dishwasher constantly draining Balay, Constructa, Kuppersbusch, Neff, Siemens, Tecnik.

The impeller Jug used in this video

Neff dishwasher safety switch float

Siemens diswasher impeller jug

Tecnik dishwasher  flow meter

Balay dishwasher  flow meter impeller jug

Constructa dishwasher water valve

Neff dishwasher safety switch float




Your Balay, Constructa, Küppersbusch, Neff, Siemens, Tecnik dishwasher is over filling or just keeps filling and emptying with water? This video will show you how to diagnose the fault and replace the faulty parts in your Balay, Constructa, Küppersbusch, Neff, Siemens, Tecnik dishwasher.

Balay, Constructa, Küppersbusch, Neff, Siemens, Tecnik dishwasher keeps emptying and filling this video will show you how to diagnose the fault and replace the flow meter (impeller jug) water valve and also we will show you how the float safety switch system works.

If your Balay, Constructa, Küppersbusch, Neff, Siemens, Tecnik dishwasher is over filling or constantly pumping out is a good indication that the flow meter or impeller jug has gone faulty. It can also mean that the base of the machine, where the electrics are, is getting water into this compartment and therefore due to safety reasons the machine´s safety switch floats, and therefore pumps the water out of the machine to stop the machine actually flooding the electrical compartment.

You can see here some of the components of the dishwasher, where the base float switch is, and the water valve that goes into the flow meter.

 

3 Responses to “Dishwasher constantly draining Balay, Constructa, Kuppersbusch, Neff, Siemens, Tecnik.”

  1. Peter B Carter says : Reply

    Good morning,hope you can help me we have a siemens dishwasher type SE26T252GB the ‘check water’ light is permanently lit.I don’t think the pump was working,I have now replaced the pump and it is definitely working,the ‘check water’ light is still lit and the water is still sat in the bottom of the machine.Any advice would be appreciated.
    Cheers Pete.

    • check the dishwasher is empting by getting it to pump into a bucket as you may have blockage on the sink fittings or one of the pipes

      • Peter B Carter says : Reply

        Checked as you suggested,pump pumping,all the fittings and pipes clear.looks like the next thing to look at is the flow meter.

24h technical help answers

Leave a comment below or click the banner above to ask your own question.

TOP