Refine your search
You can refine your search further by entering make and model number if you are looking for parts. If you are looking for tutorials please use appliance type only. If you need help please use FAQs or ask a question in contact us page (make sure you have full model number)
Having trouble with layered Navigation? Watch Video
We're busy building a brand new shop! In the meantime, find what you need at our partner website.
Our How-to-repair stores
Hotpoint Condenser Tumble Dryer TDWSF83BEPUK F12 and F19 errors
TDWSF83BEP on 15min timed programme runs til 5 mins remaining, both high & low heater sides run at approx 10amps for 5 mins then drops to approx 5amps just low side(heats, spins both ways, pumps etc.up til this point) carries on for several more minutes then F19 error. Heat element 2 x 1200w, 42.5ohm each total=85ohm. Heat stat (type261/bp 180deg 20-16)180deg cut out reads short cct, heater ntc (type 279 23-16 3111 T200)approx 12kohm @ 20deg, decreases with heat. Fan ntc(2790046 48-16)12kohm @ 20deg approx decreases with heat. Fan, ducts, filters, condenser, water reservoir all cleaned and clear. Flood float reed switch normally short cct (empty reservoir), open cct when lifted. Condenser reed switch normally open cct, short cct when condenser unit in situ. Control bd diodes, resistors, caps all within reasonable tolerance, relays operate in-cct with 9v applied, short or open cct.
Display bd checks ok, mom switches, diodes. leds, resistors ok. Max6959 (display interface) not tested but appears to function ok, 7 segment display working ok.
Wiring checked for continuity, shorts, leaks etc all ok.
Direct drive motor not yet checked, cct bd on motor, Askoll type TA0200, would need to remove bearings to gain access to cct bd.
Is the motor/cct bd the likely culprit here?
Apologise for lengthy detail but driving me nuts, thanks.
Hotpoint Condenser Tumble Dryer TDWSF83BEPUK NOT HEATING ,DRUM NOT TURNNING FO6 CODE THERMOSTATE OK MOTOR NOT TURNING
COULD IT BE THE RELAY ON PCB BOARD
Hotpoint Condenser Tumble Dryer TDWSF83BEPUK Sensor strip broken off
Metal sensor strip caught up in clothes & snapped off.
How can I gain access to attach a new one. Do you sell the part I need? Does one end attach to a spade connector?
Hotpoint Condenser Tumble Dryer tdwsf83bepuk Clothes not drying
Hello. I need to find some thermostat for my dryer mentioned above.
Could you help in locating were to buy from as I am finding it difficult to find some for model no tdwsf83bep. Thanks.
Hotpoint TDWSF83BEPUK tumble dryer keeps cutting out
My tumble dryer runs for about 20 minutes and then cuts out, I pulled the machine out on tilted it backwards there was a bit of water on the floor, I checked the condenser for any blockages then I tried the machine again and it worked but on the next cycle it stopped working again.