Hi Elaine  if your Bosch Avantixx dishwasher SGS45A02Gb 36  does not empty you either have a pump blown or there is a blockage in it. see videos below 

    Hi Antoine  I don’t know if you have seen these videos below but first check the water valve then have a look at the  impeller jug this is a common problem. 

    Hi Peter  These videos will help you change the pump 

   Hi TomThe first thing you need to do is find your full model number this is normally located inside on the stainless steel at the top of the door just inside but i think it is model number SMS50E02UK/01. if your bosch dishwasher is showing the E24 or E25 fault then this is pump problem .You will need to take

    Hi Denise  There is either water in the bottom of the machine that is activating  the float switch or you may have a problem with the impeller jug this is the part in the picture.    

      Hi the error code A10 relates to this from what i can see A10 Fill solenoid triac error detected Check water inlet valve Check wiring Check electronic control PCB

  Hi nick There is a chance that when you replaced the impeller jug you might not have done the clips tight enough, if you used the old spring clips then the pipe has gone slight hard over time and the clips aren’t strong enough i would replace them with jubilee clips. If there was

    Hi Phil This can be many things, i would check all these. the motor and the element  these are the most common that go to earth. then i would check the wiring especially at the bottom where the door hinges, you might also have the bottom full of water from a leak on the

    Hi Jerry if the appliance was filling with water before and did not stop filling, I don’t think it was the coil that was the problem it sounds like it was the valve itself: this could be caused by a few problems,      you did not put it back together correctly  there

Hi ziggy this normally sounds like a water fill problem you will first need to check the water valve is good please give me your model number to help further paul ziggy Hi again I took the valve of to check it and it looked ok but after the machine has started to fill and