The fridge is not cold at all and the freezer is around 3 degrees Celsius. It used to be a bit noisier intermittently but now has a constant low level hum.

The fridge compartment has not been cooling fully.

Following your video’s I tested the thermister’s and they were ok. I also check the resistance of the heating element and there is no continuity.
I suspect the heating element is faulty and have removed it.
With the evaporator fully defrosted the fridge is once again cool, but I suspect that without a heater it is just a temporary fix.

The heating element has the following part number

DA47-00460A

Is this a part you can supply?

Thanks

Mike

Hi

Freezer section not freezing and error A2 appears.

Thanks

Turn off and let warm up. Then restarted fine. After 12 hours warmed up again.

I installed one Elitech STC 1000, but I do not know where it is best to mount the temperature sensor.
I initially mounted it on the right side wall, but as soon as I open the door, warm air, warm air goes inside and give the startup command.

i have used your brilliant videos to help me check the the NTS sensors and the thermal fuse, which are all fine. There is infinite resistance to the defrost element. I need to purchase a new defrost element for my fridge. Do you have one in stock?
thanks for all your help.
Liam

I have had problems with my Samsung RS267lash Fridge over freezing and causing inside middle vent hole and fan to eventually freeze to point of no airflow , then fan grinding eventually to a halt from being frozen.
When I force the fridge into defrost mode, it does not seem to melt the ice either.
*Theoretically, if I force it into Defrost mode, the heating elements should come on and should be able to test 110V Correct?

Don’t think it’s a bad Defrost heating element , last time I checked this it showed 96 ohms
Defrost sensor (yellow) was +- 2K at Room temperature.
Thermal fuse (Red black /w white foam) = 0 ohms

Not sure what to do now.

the cooler section stopped working – and became warm. We thought it might be the fan which has frozen and so we defrosted the appliance overnight. There was a lot of ice! now the alarm is going and I wonder what the correct temperature is to set it.??

Hi Paul . I have this Zanussi from a year and half now PNC nr 925993083-01. The fridge is not getting cold . I already have checked evaporator fan motor , evaporator . Everything is working in perfect order . The air duck is clear , no ice . The freezer is -23 grade . I don’t know what’s wrong with that . I checked on the back of the fridge where is defrost timer , there is a sensor . I do not know what role this sensor play . May be this sensor is defective . Can you help me please ?

My Beko American Fridge Freezer needs a new gas bottle…. I’m near Almancil Portugal where can I get a replacement?
We have a BEKO American Fridge Freezer.

Model number…. GNEV321APX

I’ll send a photo of the gas bottle we need replacing. …

Thanks for you help