Hi the error code A10 relates to this from what i can see A10 Fill solenoid triac error detected Check water inlet valve Check wiring Check electronic control PCB

  Hi nick There is a chance that when you replaced the impeller jug you might not have done the clips tight enough, if you used the old spring clips then the pipe has gone slight hard over time and the clips aren’t strong enough i would replace them with jubilee clips. If there was

    Hi Phil This can be many things, i would check all these. the motor and the element  these are the most common that go to earth. then i would check the wiring especially at the bottom where the door hinges, you might also have the bottom full of water from a leak on the

    Hi Jerry if the appliance was filling with water before and did not stop filling, I don’t think it was the coil that was the problem it sounds like it was the valve itself: this could be caused by a few problems,      you did not put it back together correctly  there

Hi ziggy this normally sounds like a water fill problem you will first need to check the water valve is good please give me your model number to help further paul ziggy Hi again I took the valve of to check it and it looked ok but after the machine has started to fill and

Dear Paul I am having problems with my Bosch Dishwasher SGS45E68GB/68 it seems to be over filling with water and always emptying. Thanks in advance for your help Susan Hi Susan we have a video on this problem it’s the flow meter or sometimes called the impeller Jug Here is a link to the video