Hotpoint Tumble Dryer TDWSF83BEP F06
HelloI need some advise with respect to what I should change on my dryer. It initially came up with an error code of F04. I reset the error message and now it comes up with error F06. When I switch it on the drum turns and then after 20sec the dryer stops and the error message flashes. Please help! Warm regards Aftab
Aftab
I will try and help with this problem Hotpoint Tumble Dryer TDWSF83BEP
the first error F04
- Heater relay or heating element faulty 6th Sense light on or flashing
- Check wiring to heater
- Check wiring to thermostats
- Check heating element
- Check thermostats
- Check control board
the second fault is F06
- Heating element NTC error detected 6th Sense and Drying lights lit or flashing
- Check wiring to heating element NTC
- Check heating element NTC
- Clean any fluff or lint from the sensor and surroundings
I would have a look at the heating element first
List of spare parts for Hotpoint Tumble Dryer TDWSF83BEP
https://svcs.ebay.com/services/search/FindingService/v1?OPERATION-NAME=findItemsAdvanced&SERVICE-VERSION=1.0.0&SECURITY-APPNAME=Ferdinan-h2rliste-PRD-95d705b3d-1d9306c9&RESPONSE-DATA-FORMAT=JSON&GLOBAL-ID=EBAY-GB&affiliate.trackingId=5338688226&affiliate.networkId=9&REST-PAYLOAD=true&paginationInput.pageNumber=1&paginationInput.entriesPerPage=12&keywords=Hotpoint+TDWSF83BEP+Tumble+Dryer&descriptionSearch=true
My TDWSF 83bep hotpoint humidity sensor has been removed and I will replace it but the screen is not working when I switch the machine on. Is that because the sensor is not connected or has the board gone. Thank you Paul
Hi my tumble drier has stopped working it’s come up with fo4 all lights for door filter bottom filter and water drum full I cleaned all these out but lights still flashing can you help please
Hi,
My Hotpoint TDWSF83 EPZ (UK) condensing dryer’s belt broke.
I managed to get the belt on but its too slack. Everytime i put the motor in place to get the correct tension, then connect the spring it pulls the motor back therefore releasing the tension.
Hopefully i’m missing something simple, any help is appreciated.
Cheers Lee