Refine your search
You can refine your search further by entering make and model number if you are looking for parts. If you are looking for tutorials please use appliance type only. If you need help please use FAQs or ask a question in contact us page (make sure you have full model number)
Having trouble with layered Navigation? Watch Video
Our How-to-repair stores
Whirlpool washing machine not spinning or turning, How to replace the carbons in the motor
To order your carbon brushes for your washing machine, you will need the full model number of the ID Plate, which you can normally find on the inside of the door frame or in the rear of the machine. Sometimes you will need the 12 digit number, which is usually prefixed with 12NC in front of
How to enter test mode on Whirlpool AWO/D & AWD Series Repair Faults & Test Errors
This video will show you how to enter your Whirlpool Washing Machine into test mode and diagnose the fault codes on AWO/D & AWD Series and general Whirlpool washing machines that may not relate to models sold outside Europe, especially models sold in the USA.We are working on a Whirlpool, but this video is also
How to test a washing machine motor
How to wire up a 6 pin universal ac 240v motor on a washing machine. AEG, Ariston, Baumatic, Beko, Bosch, Bush, Candy, Creda, Electrolux, Hoover, Hotpoint, Indesit, LG, Samsung, Servis, Siemens, Smeg, Tricity Bendix, Whirlpool, Zanussi, ETC
How to replace a Zanussi washing machine door seal.
To order your door seal you will need your full model number. (This is normally around the washing machine door frame on a sticker)
Whirlpool AWM 5145/4 857051415290 washing machine trying to find parts
iam looking for a motor for my washer i have tried changing the cabons but motor shorts and need to replace it
whirlpool wfw9250ww00 washing machine leak at front water runs down the weight then falls to bottom
washer leaks at end of cycle on high speed spin. mostly after large loads. small loads and regular spin does not leak. Have replaced door seal. Have removed weight and there is water at the location on the middle weight bolt.
Whirlpool Washing Machine WWDC64001 Not starting program
Service and start lights flashing and wash and rinse lights staying solid green ( lights 2 and 3 from left to right).
When put on drain cycle, you can hear the pump going fine. Tried spin cycle but flashes error code straight away. Checked and emptied pump and both carbon brushes are fine. Any help would be great. Many Thanks, Marc
Whirlpool AWO/D 7120 washing machine will not complete diagnostic
Hi,
my washing machine does not have the digital display and when i start the dianostic cycle, the red leds come, it starts the diag cycle but then all the leds go out and everything stops. Then after about five seconds the green led start lights up and dflashes as though it is ready for use. I have sent the board off to be repaired and it came back. I fitted this with a new door switch and everything was OK for weeks but now this problem has occured. can you give me any clues please.
Thanks Nick
Whirlpool WFC7500VW2 washing machine with F06 possible carbon brushes
I have the motor out but do not see the a part # on the brush but I can provide any # off of the C.E.SET motor that is needed. I also need a belt for this as well and if you could tell me how much these parts are roughly in US dollars it would be helpful.