E51, E52, E53 & E54 Tumble dryer error code Electrolux, AEG & Zanussi
E51, E52, E53 & E54 Tumble dryer error code Electrolux, AEG & Zanussi
Error code family E5? is 5 flashing green lights followed by a number of red flashing lights?
These error codes are for ENVo6 Cuirct boards on these tumble dryer Electrolux, AEG, Arthur Martin, Elektro Helios, Eureka, Faure, Frigidaire, Gibson Appliance, Husqvarna, Kelvinator, Marijnen, Parkinson Cowan, Progress, Simpson, Tornado, Tricity Bendix, Volta, Westinghouse, Zanker, Zanussi & Zoppas.
On all of these faults if you hear a humming noise then it could be a capacitor!
E51
Motor power triac short-circuited.
Possible fault Motor faulty; Wiring faulty; Electronic board faulty. Machine Status/Action Cycle interrupted.
E52
Intervention of motor overheating safety cut-out.
Possible fault Motor faulty; Intervention of motor overheating cutout; Wiring faulty; Electronic board faulty.
Machine Status/Action Power to the heater unit and reversal of the direction of rotation are interrupted. If the problem does not re-occur, the alarm is memorized and the cycle continues. If the fault persists after several attempts to supply power (about 35 min.), alarm E51 is generated.
E53
Motor triac “sensing” circuit faulty.
Possible fault Electronic board faulty. Machine Status/Action Cycle interrupted.
E54
Motor in-operational.
Possible fault Excessive wash load; Voltage too low; Motor/transmission system inoperative.
Machine Status/Action Cycle paused after several attempts at powering the motor.
-
E21, E22 Error Code, Tumble Dryer Pump Fault AEG, Electrolux, Zanussi Etc
-
E61, E62, E63, E64, E65, E66, E67 Tumble dryer Error Fault Code Electrolux, AEG, Zanussi
-
E51, E52, E53 & E54 Tumble dryer error code Electrolux, AEG & Zanussi
-
How a NTC Sensor works on a Tumble Dryer
-
Tumble Dryer fault code errors Aeg, Electrolux, Zanussi Etc
-
How to service a Condenser Tumble Dryer pump unit.
-
Printed Circuit Board Repairs for Tumble dryers AEG, Electrolux, Zanussi Etc