Beko Drvs73w condenser tumble dryer 7kg sensor drying Not heating enough

Just fitted new heater iv noticed only bottom 2 elements will heat up for few seconds then goes off,then 2 top elements will heat up? Not the 2 bottoms one's 🤔

Adrian

I will try and help with this problem Beko Drvs73w condenser tumble dryer

Adrian, a few issues might be happening with your tumble dryer. First, there are sensor bars inside the drum that detect moisture in the clothes. If these have a built-up film, they could give false readings to the circuit board. Make sure they're clean before looking into other problems.

There's also an NTC sensor at the front of the machine that might be faulty. However, check the sensor bars first. If your heating element is new and undamaged, a faulty relay on the circuit board could be causing the problem.

In my experience with tumble dryers, it's often simple faults that stop them from heating correctly. Don't forget to check the vent tube if it goes through a wall. Any blockages in the ducting system can cause the thermostat to give false readings, turning off the heating system early.

Watch the video I've included about cleaning and maintaining your tumble dryer. It shows you how to clean the sensor bars and keep your dryer running smoothly.

If you want to support the site please mark us to your favourites, also I would be grateful if you would subscribe to our social media channels as this really helps my site and keeps us going.

YouTube. http://www.youtube.com/user/howtorepair
Facebook. https://www.facebook.com/how.to.repair.appliances
And if we really helped you save money you can always click on the Buy Paul a Beer page