Hi Risto  you could solder them but look for faults on the board, 90% of all problems like this are are down to bad electrical supply small supply or not enough power at sauce i have had many faults on these in Portugal also with washers,      Hi Risto   Iam glad you got it all working

   Hi  Steve  the first thing I would check is the  thermostats There are two on the heater,  and normally 1 on the ventilation tube inside the machine,  this may either be an NTC sensor or a conventional thermostat. The heater element has a high and low side you need to check booth circuits. Another common fault is

    Hi Stuart i need to know which thermostat you mean as there a few on your neff R4380XOEU/04 i have added the exploded digram below to help you Common questions people ask about on neff R4380XOEU/04 model of tumble dryer.Neff Tumble Dryer Not Turning or spinning, no drum action – these are all belt, capacitor, motor related or you may

    Hi Ben  The wires go:-5= pink/white 4=orange 3= gray 

    Hi Joseph Double check the heating element, and also check again the front stat if the pcb is not getting the right reading it will not heat up. when you have checked that the wiring is good and ntc and heater then it might be a fault with the pcb 

        Hi Sergio,  Given the pictures you sent and the model of your tumble dryer the correct part is this one here 

    Hi Alexander  To do a live test on a motor like a pump there are only 2 connectors usually live and neutral if you Know what you’re doing with electric you can connect it up to test it but make sure it’s a 240v pump 

    Hi Philip First Philip i think you mean TVM562 not TMV562 as there is no such model. I have put a list of everything i would change under here on your Hotpoint Aquarius TVM562 tumble dryer i hope this helps and i’ve added a load of videos underneath to help you repair it. Just click on links 

    Hi Barry   this is the belt for your dryer Bauknecht TRKK7869ex it is a DRIVE BELT 1936 mm long and 6 ridges it should have something like this stamped on it 1936H6 

    Hi Trevor  this is the right element for your model listed below. just click on the picture. there is genuine and pattern available make sure you hoover out the machine while you are doing the job as it helps a lot with maintaining the machine.also fits any of these candy models GO C 21880, GO C218/180, GO C58F80,