Hi Paul, just located and tested the exhaust thermostat you mentioned and that also has continuity so now I’m really puzzled. Would it be worth retesting the inlet & exhaust thermostats with a heat source (hairdryer etc) to see if they will go open circuit?
(0312 447 15002/1)
heater element -ok reads 47ohms on both (no s/c to ground)
inlet thermostat continuity- ok (0.03)
safety cut-out stat (red button)- no defined click but will read open and closed
– exhaust stat – not checked

Hi Paul

Should I get continuity on both heating elements? I am only getting on one. How do I test the ntc sensor ?

Hi Paul, Thank you for getting in contact, It’s a Hotpoint Reversomatic on the inside of the window door are the numbers 9320A/1 and then 12 620410.
I hope that this identifies the model to you. I have bought a belt but how do I get the front off this model,I have watched your videos hor the more recent models but this is an older model

Iv checked heater element on multimeter so board fault.
If you could help much appreciated

Cheers

Followed the instructions on your video but the belt seems slack

CHECKED THE TWO THERMOSTATS ON THE HEATER AND GET CONTINUITY ON BOTH. CHECKED FROM THE COMMON TO THE HEATER ELEMENTS ONE OF THEM I GET CONTINUITY AND THE OTHER I JUST GET AN OHMS READING OF ABOUT 124 OHMS. HAVE YOU ANY SUGGESTIONS KIND REGARDS DAVID

Hi, I have the above tumble dryer and water seems to drain at the back of the machine leaks on the floor and not though the water tray, could u plz advise me on the part i need thank you peter

hi we have a logik ldv6w13, heating element changed and thermostat, but still blowing cold air, any idea to what it may be, thanks.

Starts ok, runs for 3-4 minutes,then faults,but after a few resets will run through full cycle

Need capacitor. Not sure what size to get.