How to replace a tumble dryer belt Hoover or Candy

by / Saturday, 29 October 2016 / Published in Belts, Tumble Dryers




How to replace a belt on Hoover or Candy tumble dryers

Search and purchase
Tumble dryer belts

Removing facial panel to gain access to screw

Removing facial panel to gain access to screw

Remove screws a base

Remove screws a base

Remove door

Remove door

undo all wiring that is in the way. Take phots

undo all wiring that is in the way. Take phots

Hoover and Candy tumble dryers are notoriously hard to work on, specially if you don't know how they are put together and don't have anybody to help you out and give you a few hints. 

This video is on a tumble dryer that is not turning. There are only really three reason for a tumble dryer drum not to spin. First one is a complete failure of the motor or the pcb, second one is the capacitor failure and third one is you hear the motor running but the drum does not turn, indicating a snapped belt. A lot of our customers and YouTube viewers haves asked us how to change the belt on these tumble dryers, so we'll do just that even thou the belt on this machine is just fine as you'll see later in the footage.

To reach the belt  you'll have to strip the front off completely, please follow the procedures on the video, slowly and methodically and you should be alright. In the event you find yourself stuck at any point you are more than welcome to contact us as we do go out of our way on occasion to help our customers and viewers.

While you are at it do take the opportunity to clear all the fluff you can, as it improves the useful life span of your hoover candy tumble dryer.

Before you start any investigation of the fault or even remove the lid of your tumble dryer please watch our videos and fully understand them in full and pay particular attention to the safety and information notices

Please remember to support our site by buying spare parts from our store and, if you decide we really heled you can always share the site with friends.

There are loads of video below to help you repair your tumble dryer condenser or vented and they will help you with all these makes Hoover or Candy tumble dryer and some Maytag, Helkama, Kelvinator, Otsein, Teka, Terzismo, Zerowatt models.

 

Check the old belt size this in a 1930 mm belt also clean all fluff

Check the old belt size this in a 1930 mm belt also clean all fluff

Fit new belt around the pulley wheels

Fit new belt around the pulley wheels

Fit new belt around the drum

Fit new belt around the drum

Replace front carefully after replacing belt

Replace front carefully after replacing belt

One Response to “How to replace a tumble dryer belt Hoover or Candy”

  1. Gordon says : Reply

    I have a Hoover aqua dynnamique . When I turn it on it just hums and doesn’t turn . If I open the door and push the drum around a little bit then close the door and push the button it will work . Does it need a new belt or just adjusting . Also on each how much will it cost. In advance thank you for your help.

24h technical help answers

Leave a comment below or click the banner above to ask your own question.

TOP