Do you have any second PCB boards for sale? PCB is made by Bitron 40006187

Will run for 30 mins then stops. Clothes seem no dryer. Error E 60. Have cleaned condenser and filter. Tank empty.

Hello! I have a dryer from Privileg with the Circuit board LP 712236 – exactly like the one you showed here in your video: https://how-to-repair.com/help/printed-circuit-board-repairs-for-tumble-dryers-aeg-electrolux-zanussi-etc/ . I checked the relays on it and one seems to be broken… no “clack” when I tested it with 9V. All others are fine. The white relays are specified with SHC SRE303012. Do you know what relay to buy to replace them? I can’t find the exact same anymore….

With greetings from Germany,
Matthias

front panel lights up press start flashes red not starting pnc number 91609737900

How certain can I be that the heater itself is the issue. I don’t have a circuit tester to test the thermostats as shown in your videos. Do I need one or should I just go ahead and spend £70 on a new heater? Thanks and regards.

We have followed your instructions on line and taken it apart, cleaned the machine and sorted parts out but the drum dos not want to move and the machine comes on and nothing happens.

when set to auto dry, the washer dryer leaves clothes damp like the drying cycle only run for 1/2-1 hour. can take 4 hours to dry on manual(cupboard dry)

Need to know if pcb or heater element to replace. Already swapped NTC on front.

Thanks Paul

After several minutes it shows fault lights for ‘Filter’ and ‘Tank’ but we have thoroughly cleaned the filter and emptied the tank

My Tumble Dryer is very noisy – a constant wine or buzz. The noise seems to happen regardless of whether the drum is turning or not, but stops during the “cooldown” phase of the cycle. The tension pulley has been replaced but the noise remains. Any advice?