Not drying, everything appears OK but it’s very humid in the drum and taking hours and hours to dry. Pump appears fine and drain isn’t blocked.

E21 fault on my tumble dryer

Hello
We have a Beko DCU7230W (7182681500) s/n 12-210450-10 dryer. The NTC thermister on the heater unit has gone faulty (eg. gives about 450 ohms at 20-25degC) so the elements won’t come on, ie. no heat. On the component it is marked as ELTH, Type 279, T175, 3116/37-12. I’d like to buy a cheap new or used NTC to replace it rather than a whole new heater unit with the stat and NTC included – but cannot seem to find any online.
Please do you know where I could buy the part.
Also, please, might you be able to explain the meaning of the numberings on our part ie. T175, 3116/37-12 – are they significant and need to match a new replacement or is it just the “Type 279” that is needed. For example I’ve seen a cheap “Type 279, 3088/45-07” and “Type 279, 3088/35-11” and “Type 279, 3088/47-12”.
Many thanks if you can advise with reply please.
John

Hei!
My dryer just stopped working. There is no light or sound from the dryer. There is power to the selector switch, but only 15 volt to door switch. Can you please help?

Best regards
Johan

Wonder about prices and shipping time? Thanks. Oh, we do smell sort of a cigarette smell when we took the back off.

no working

CANDY GVC D91CB-80 CONTROL PANEL REMAINS BLANK WHEN THE MACHINE IS SWITCHED ON IN ANY SETTING.
ELECTRICAL SUPPLY AND FUSE HAS BEEN CHECKED AND ARE OKAY.THE MACHINE HAS BEEN WORKING FOR THE LAST 18 MONTHS.

Hi Paul,
I have this AEG tumble dryer and this A50 error appeared recently, the certified technician can’t find out if the issue comes from the electronic board or the motor. Can you help me?

Hi Paul.
Our Zanussi Condenser Dryer has started to stop mid-cycle. It runs for about 5 only then stops.
I have faithfully cleaned out the fluff filters in the door and body as well as the condenser itself so I don’t think the lies there. I have also cleaned out the front “hollow” space in the body running from the filter downward to the base of the front where the condenser is located, as best as I could. I found there was water in the space at the bottom of that area which I hope is normal – given it’s a condenser.
I replaced the capacitor in January this year when the drum would only rotate when it was given some assistance by manually rotating prior to shutting the door and then starting.
I am at a loss. Could you please assist?
I would appreciate it very much…and it would make me a hero once again) to “er indoors”.
Much obliged.
Trevor

After starting the drying cycle it stops and all lights are flashing and it feels a bit too hot.