Hello.

My tumble dryer powers up and allows me to select a program, but the program doesn’t start. This was initially intermittent – but now wont go on at all. I’ve entered test mode and noticed that the fan doesn’t go on during “fn:on”, the drum does not spin during “dr:rr”. I get as far through the test as “Sc:Er” and then can’t get progress further.

Any advice to diagnose what’s going on would be much appreciated

Thanks!

I think I need a circuit board for the dryer, how much are they pls

Hi, pump runs when 230v placed across the terminals, float level switch opens/closes, continuity of cabling from pump and switch to PCB connecter confirmed OK
I suspect main board but cant remove knob to examine board, thoughts?
Chris

After watching your great videos. I have replaced all thermostat and the heater element but still stops after a few seconds with the lights flashing. a couple of times the heater did start but the stopped and beeped again. I think the only thing it could be is the PCB board part number 40005134. Would i be able to buy one or send it of to you for repair.

Thank you.

Hi, The drying machine is not turning on, no lights on in front panel when I switch to any position. I also tried to enter in test mode, no results Is there any fuse to check? Thanks in advance for your help. Jose

Hello. My mum tells me her dryer is doing the following.
– Runs for approx 60 minutes then stops and the empty water light turns ON.
– Check of the water tank finds there’s not a lot of water in it.
– Emptied water tank.
– Dryer won’t restart after 5, 10 and 15 minues have passed but will start after 20-30 minutes has elapsed since stopping.
– Dryer then stops again after approx 60 minutes with empty water light ON.
– The above repeats.
– The dryer is heating up, turning and changing direction.
– There are no other lights on except the empty water when the dryer stops.

It appears the dryer is cutting out and with it being able to restart after 20-30 minutes perhaps though this was the thermal control cut out but the empty water light is a question mark given the water tank is no where near full – to quote my mum ‘there’s hardly any water in the tank when it stops’.

I’ve watched your excellent video about servicing a Hoover dryer and hope you’ll point me in the right direction before I buy the parts to fix it. I see Hoover supply pressure switches, NTC’s and heater but not the thermostats (that I could find in the spares list).

Any advice about possible cause and parts would be very much appreciated.

Thank you.
Rob

I turn the dryer and when I go back to it it has stopped and all light flashing

When starting the dryer after a few seconds there is a single beep and then the lights flash 5 times. The dryer continues turning but there is no heat.

As soon as you put the tumble dryer on for a cycle it runs for 10 seconds and dont get hot then starts beeping and flashing

The dryer switches on and rotates, but no heat is generated. Have checked and cleaned the filters and still no heat. Initially was intermittent, but now seems to have packed up.