My Miele WWB020WCS Washing Machine machine is fixed at the error code -0-

On all settings, except for delicates, which shows the timestamp 0:00. But nothing operates on the touchscreen at all. I have done my best, calling Miele and scouring the Internet for help with this error code -0-. I have unplugged the machine and let it sit for, everything from 1 minute to 2 hours before plugging it back in and opening and closing the doors 6 to 12 times to try to do a hard factory reset. Nothing is clearing the zero error code. Any help would be greatly appreciated. Sincerely,

Eric Walker.

Happy to contribute to your channel and send you guys some beers!

Great videos Paul and at the right pace and detail for us older generation.

Stripped my Hotpoint WMPG 742 Aquarius washing machine with collapsed drum bearings today.. It defies sanity when you have to scrap a whole drum instead of replacing bearings. Manufacturers should be ashamed of they’re throw away world.
As our machine was 8 years old I opted to buy a new machine instead of paying £150 for a new drum.
I have the old 3 phase motor, pump, control board, water valves etc etc available if you want them for anyone. All serviceable. You can have them for free just get them collected.
Keep up the good work, I wish I had a hoist those concrete blocks are quite hefty until removed.

Great

My Bosch WAE28462GB/97 Washing Machine’s drum began to move in short ‘pulsed’ motions and then F21 code appeared.
Have removed motor and brushes look fine (plenty of length and no obvious damage). I did notice some black deposits under the machine and at the rear of the motor there are some small crust like black deposits around the wide circular piece below the main frame of the body. Any help is appreciated. Thanks.

Beko WM94145W Washing Machine wouldn’t start, unless you banged the door 100x. Replaced the lock it started straight away, water flowed and cleared the powder, however then there was a click and it stopped. The door could be opened straight away. I took the seal off again and turned the connection around, (it fitted both ways although your video said it should only fit one way), now it isn’t working at all. Any suggestions? Is the lock I bought through Amazon faulty? Thanks, Sophia

Hi Paul hope you are well..I’ve got this Miele Wt2780 Washer Dryer will not complete sensor dry cycle, continues at 10 mins left? Will do a timed dry no probs, have had dryer nth and element changed…your help much appreciated..

LG WM3470HVA Washing Machine won’t lock and when it tries to sounds very weak.

Samsung WD90J6410AW EcoBubble washing machine keeps showing HOT ERROR IT APPEARS even when using only wash cycle without drying the clothes it stays for hours before I can open the door.

Beko Wmb71231b Washing Machine’s Drum offset and rubbing, causing smoke and gas burnt
Through the putter drum causing it to leak.

During the last wash our machine started making a loud popping/snapping sound and I haven’t found out how to fix it yet. Do you know what it might be?

Washing machine: Samsung Ecobubble WW80J6403EW

Information:
-It only makes the sound when the belt is on and it spins
-I’ve replaced the belt, didn’t fix it
-I removed the heating element and cleaned behind it. The sound also occurs when the heating element isn’t in place (but belt is on)
-I checked the filter and cleaned it

I’ve uploaded a short video of it here:

The hinge is still attached to the Hotpoint Ultima WMUD1043 Washing Machine with all the screws. The plastic on the door looks worn away from where the screw holes are. Is it possible to replace the inside plastic part of the door. If so where can I obtain this part.