Hi,
I replaced the main board for my Hoover tumble dryer. It was advised to run the self diagnosis test before taking the dryer to use after replacing the main board. However, the machine won’t do that even though I try doing it following the intructions that came with the new main board:
-Turn the program selector knob 2 steps in clockwise sense from the OFF position.
-Push and hold the first option button to the left of the display. That should turn ALL LEDs on and the display should show the last thtee digits of the Eeprom Code in memory. THAT DOESN’T HAPPEN.
-Within 3 seconds from the moment all LEDs are ON, push the Start/Pause button. But as tje LEDs won’t go ON, it doesn’t help to push the button either.

Just to say I sent amessage asking which was the right part for my tumble dryer. I have found it thank you. Please disreagard my request. thankyou Carrie

Start pause button flashing red with 3 beeps. The machine will run if you turn the dial and quickly press start. It then beeps regularly (5-10min?) through the cycle. If you do not press start quickly it will flash red and beep and will not start.

The machine has a 30min cycle that does not use the “auto dry sensor” once in this cycle it completes with no beeps or red light.

So my suspition is the “auto dry sensor” or related fault.

Was hoping you could inform me how to enter diagnostic and test this?

Waring light keeps flushing and condenser has been thoroughly cleaned as well as the inside of the machine.I am stumped, any help appreciated as it is a cracking Tumble Dryer and have only had to replace a belt up till now. Thanks

Keeps flashing up err15 code. tried unplugging for 10 mins but doesn’t clear error so think I need to do a reset but dont know where the reset switch is located. I think it has tripped due to me not emptying/cleaning the condensor unit recently because when I checked the unit it was pretty full of fluff and also feathers/down that had come off a duvet cover being used on a new feather duvet so I assume it has caused it to overheat and trip the sensor??? Can you jut tell me how to do the reset so I can eliminate that as the reason?? many thanks.

Good morning, I have had this tumble dryer for a few years now and recently I have noticed that when the Float rises up and pressed the float switch. The Empty water light comes on. My question is…. should the machine cut out when the empty water light comes on? and if so what parts should I look into to replace this fault?

No heat just cold air

Continuity good on heater element and the two thermostats on the heater assembly. This model is different from the video. No 3rd thermostat in drum. Could it be the circuit card?

I have cleaned all the filters and the area they sit in but this hasn’t helped. The pipe that brings the water to the reservoir is just inside the door so i blew back don’t it to check for a blockage. there was resistance and then it freed and there was a gurgling sound…..however, after leaving the dryer to run for a while i stopped it to check the pipe again and had the same resistance. please offer some help as this is really pi55ing me and the wife off:)

power on to main pcb but mc not doing anything . suspect pc board 40008456 is this the same as the hoover board as these seem a lot cheaper but are same number ? or are there slight differences in card . thanks Paul