Samsung Washing Machine HE or TE Error Code Heating Fault

This video will show you how to identify your 3e error code fault and replace the motor or carbon brushes 3E error code is a Motor tacho fault detected Can also be caused by be main PCB   If the motor tacho signals are inputted less than 2 for 2 seconds after main drive motor

 When looking at the dial on a Beko washing machine treat it as a clock 1 to 12 as in picture. On some models you may have more programs but for the basic access into the diagnostic mode is the same the same Start by turning the washing machine of with door shut.Now turn the

 To order your carbon brushes for your washing machine, you will need the full model number of the ID Plate, which you can normally find on the inside of the door frame or in the rear of the machine. Sometimes you will need the 12 digit number, which is usually prefixed with 12NC in front of

   Hi AllI have been doing repairs for 30 years and I think it is disgusting that the manufactures do this on a lot of washing machines , there is no saving on the way that they make the drums like this, and there is only a few bolts that saves them few pennies. We are meant

 This video will show you how to enter your Whirlpool Washing Machine into test mode and diagnose the fault codes on AWO/D & AWD Series and general Whirlpool washing machines that may not relate to models sold outside Europe, especially models sold in the USA.We are working on a Whirlpool, but this video is also

 If your washing machine is leaking from the front of the door, or the door seal is torn, warped or damaged, or mold has built up at the bottom of the seal and it’s beyond cleaning, it´s time to replace it for a new one.This video will show you in detail how to replace the

 Beko made washing machines elements and NTC sensors are quite easy to fit and on a lot of models the control board will tell you when something is wrong.

       If your washing machine is constantly filling or filling when switched off then this is the right tutorial for you.There are basically a few reasons why this can happen and I will explain them all and how to rectify them. We have included some videos to help you understand the fill system. 

      This tutorial is for when a washing machine will not fill with water but works OK on spin. If your machine does not fill at the start or stops in mid cycle with no water in the drum or it won’t rinse then there is normally a problem with the water intake system. If you’ve