FORGOT YOUR DETAILS?

Hi my washer works but dryer stars then stops and all the lights flash and that is it. But it does start it self of

Door lock has been slowly dying and now it’s dead. We have three small children and we’d appreciate any help in fixing this

I need to replace my Hotpoint WML 730 uk Rubber door Seal
S/N 012116608 – 31740700000.
Will you please let me know if you have this in stock A.S.A.P
Harry

Hi, Would you happen to have any videos on how to replace the selector knob which is freespinning. A repair person told me over the phone that it would not be cost effective to replace as he would need to replace the entire circuit board. I cannot afford to replace the washing machine so was going to try the knob first. Big thank you for the door switch video too.it was very useful.

Watched your excellent video. Not sure how to find genuine replacement parts.

I have a Beko WDR7543121W washer dryer the door handle needs changing
I have removed the door however there are no screws visible on the inner panel
do you know how to dismantle the door

Hi
We have a WMB71642W that doesn’t want to drain. I did get the machine into diagnostic mode and it showed E05. I opened the filter at the bottom and cleared (also flooded garage). I tried the diagnostic again and the code shown up was 15 18. I can’t find anything for this but it seems that it still won’t drain. Is this going to be the pump or control board, or is it something else?
regards…

Drying cycle runs, pumps run, dryer blower fan runs, no voltage at the heating element(s), thermal cut out has continuity, another (temperature/thermistor ??) sensor mounted on the side of the heater chamber has continuity. All wire look fine/not damaged or loose. Temperature? sensor just before the warm air inlet into the drum has no continuity, suspect this is the fault?? It has numbers 12466410 and 88910511. Does this seem likely – if I’m right can you supply the spare part please?

Smell, ticking engine not spinning but rotating the washing machine drum

I looked at your video and the capacitor is doomed but other parts are sooted.

I would like to send this board to you for possible repair with quote for repair or price for new board.

Please advise if his is something you can offer.

TOP