Hi,We have used all the leading machine cleaners, without success. Could there be a build of scale and bacteria between the inner and outer drums. If so how do I get access to clean the top of the outer drum

Drain is clear. Inlet water is good. All cycles will start but it always seems to stop filling after Just a few seconds. Goes into Neverland. Just sits there

Once machine is put on to wash, it clicks and then the error message F15 appears and nothing happens.

The machine washes, drained the water, pump another water to rinse and also drained the water after rinsing but fail to spin to remove excess water

Cycle first became incomplete during a random wash.
Clothes wet but no cycle.
Showed error code E13 (water leak detected) after a diagnostic check as per your video.
There is absolutely no water egress from the machine.
Carried out the functionality check around the dial as per your video and all appeared well across the cycle.
Cleared the code and then tried a normal wash.
The water appears to enter the machine and the drum as per normal but the drum turn cycle does not appear to begin.
Any ideas or help would be most welcome.
Regards
Paul

Can you give me advice on how to clear a E18 Error on a Beko wmb71231w? I have tried everything, I have checked the pump and drain pipe, I have switched the knob to off and then to cotton while pressing Start/Quickwash & Spin. That then displays the E18 but when I press start again to self test it does nothing. I have also pressed the start button for 3-5 seconds to reset but again it does nothing. Can you please let me know what to do? Much appreciated.

Not catching to the door lock to make the washer run correctly.

Hi, would you please let us know, whether you have “bearings + sealing set” for this Bosch model available and what would be the price to ship it to Redditch? Other details: Type – WLM68 WAN28080GB 416050295900002917

Thanks a lot in advance

Just need the correct part for this washing machine please I have tried to look myself and cannot find it

Following up one-to-one consultation request for 1pm today:
I put new bearings in a Hotpoint WMA machine a couple of months ago, but evidently the seal was not right and the bearings are failing due to the grease washing out of them. I wonder if you could have a chat / look to see if there is any obvious problem with the seal and / or my installation of it. Thanks.